ASROCK iBOX-280 Quick Installation Manual
- Type
- Quick Installation Manual
Inside View
Front View
Rear View
iBOX-280
Quick Installation
Guide
M/B
HDD mounting bracket
Front Panel
Rear Panel
CPU Heatsink
SO-DIMM sockets
2 x USB 2.0 2 x COM Power LED
HDD LED
On-/o Switch
DC-IN 4 x USB 2.0 HDMI
Intel 82574L LAN VGA
Line-Out
Mic-In
Antenna PortAntenna Port
P/N: 15G06M013000AK V1.0
*15G06M013000AK*
1. Removing the Top Cover
2. Installing the SO-DIMM
3. Installing the Hard Drive
4. Installing a 2.5-inch Hard Drive
5. Replacing the Top Cover
Note
1. Remove the ten screws that secure the top cover.
2. Li up and remove the top cover.
* Please install the SO-DIMM module into the
DDR3_A2 for the rst priority.
2. Li up and remove the HDD mounting bracket.
1
2
1. Remove the four screws that secure the HDD
mounting bracket.
1
2
3
2
1
2
3
2
1
1. Replace the top cover, making sure the mark on
the top cover is aligned with the HDD mounting
bracket.
2. Install the ten screws that secure the top cover.
1
1. Place the HDD into the HDD mounting bracket.
2. Secure the hard drive into the place using the
four screws (two on each side).
3. Aach one end of the SATA 1 to 1 Power Cable
to the hard drive.
4. Secure the HDD mounting bracket to the chassis
using the four screws.
13
2
2
2
2
2
5. Aach the SATA data cable and power cable
to the motherboard.
SATAII_1SATA_PWR1
For more details on the hardware installation,
please refer to the User Manual in the support CD.
e terms HDMI™ and HDMI High-Denition
Multimedia Interface, and the HDMI logo are
trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other
countries.
-
1
-
2
