Sunrise Medical IC-5142 User manual

Type
User manual

This manual is also suitable for

Component Racking Connector
User Instructions
Model IC-5142
IMPORTANT WARNINGS
Inspect all parts for damage to the carton or its contents. If damage is
evident, do not use. Contact your local Sunrise Medical dealer immediately.
Read all instructions before using this product. Failure to follow these
instructions may result in injury or damage.
Make sure all attaching hardware is tightened securely at all times.
The recommended weight capacity of the component racking connectors is
150 lbs.
INSTALLATION
1. Disconnect head and foot springs from bed
assembly. For complete instructions, refer to Bed
Instruction Manual (IM-429000).
2. Connect the head and foot ends by inserting the
pins of the rail connectors into the hooks of the
bed ends (Figure 1).
3. Use the flat head screws and hex nuts provided
to fasten the rail connectors to the head and
foot ends. Make sure the hex nuts are placed on
the inside of the rail connectors.
4. Place head and foot springs upright across the
rail connectors between the bed ends (Figure 2).
Figure 1
Figure 2
Manufactured for:
Fabriqué pour:
Fabricado para:
Sunrise Medical Inc.
7477 East Dry Creek Parkway
Longmont, Colorado 80503
USA
(800) 333-4000
In Canada (800) 263-3390
Made in Taiwan
Fabriqué en Taiwan
Hecho en Taiwán
© 2002, Sunrise Medical 11.02
IM-429002 Rev B
  • Page 1 1
  • Page 2 2
  • Page 3 3

Sunrise Medical IC-5142 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI