Page is loading ...
EMS 1
Music Streamer
Owner's Manual
EN N
3
About the EMS 1 Electrocompaniet Music Streamer
This unit is designed to work with the Electrocompaniet PD 1 DAC only.
A radio link is established between your computer and the PD 1. This link is
used to transmit music from the USB-port of your computer to the PD 1.
Unpacking the EMS 1
Immediately upon receipt of the EMS 1, inspect the carton for possible
damages during transport.
The contents of the carton
• 1 pc. Electrocompaniet EMS1
• 1 pc. USB type 2 cable.
• 2 pcs. antennas.
• 4 pc. rubber pads.
How to set up the EMS 1
1. Antennas
Screw one antenna to the antenna port on the EMS 1, tighten it with
your fingertips, no tool is necessary. Screw the other antenna to the
antenna port on the back-panel of the PD 1, labelled RF. Both antennas
should be set in an upright position and the top point should be kept
away from any close-by metallic objects.
2. USB type 2 cable
Connect the USB type 2 cable to the USB-port on the EMS 1 and to the
USB-port on your computer.
Verify that the units are set to the same channel
Both the PD 1 and the EMS 1 must be set to the same channel. From the
factory all units are set to channel 0. If you need to change the channel
this can be done by turning the channel indicators on both units, labelled
Ch. A small screwdriver can be used.
Set-up
Once connected and on the same channel the units will connect auto-
matically. The volume will automatically be set to the preset level. If a
connection is not established, or the connection is lost, the volume will
automatically be set to 0.
The EMS 1 will replace the sound card on your computer. To use EMS 1 you
must change the sound settings to make EMS 1 the preferred sound output.
You might need to restart your media player after setting up the EMS 1.
ENG
4
ENG
If service is needed
Your dealer will have all relevant information regarding the service cen-
tre in your area and will ensure that your unit is serviced with minimum
delay. If there is no service facility available in your country, please
ship the unit to the following address:
ELECTROCOMPANIET AS
BREIVIKVEIEN 7
4120 TAU
NORWAY
Switchboard: +47 51 74 10 33
Fax: +47 51 74 10 10
Service: +47 51 74 10 23
E-mail: ser[email protected]
www.electrocompaniet.no
Service department: ser[email protected]
The end-user is responsible for all shipping charges, insurance, and re-
importation and duty charges. When shipping a product to the factory
for service, always include the following:
1. A sales slip or other proof of purchase if repair is claimed under warranty.
2. A proforma invoice with value of goods, stating that the product is
being returned to Norway for repair.
3. An accompanying letter describing faults, symptoms, or problems with
the unit.
4. Always ship the unit in its original carton and packaging material
to prevent damage in transit. Electrocompaniet will not cover damages
incurred in transit.
If you require further information concerning the operation of the unit or
if you have any questions related to service, please do not hesitate to
contact your dealer or national distributor.
8
Warning!
To avoid risk of fire or electric shock, do not expose this appliance to rain or moisture.
Verify line voltage before use.
Do not remove cover. No user serviceable parts inside.
Refer servicing to qualified service personal.
The warranty is void if the product is tampered with by non-authorised personnel.
Use only authorized Electrocompaniet service center.
LOCAL DEALER
DEALER
StickER
HERE
Made in Norway
www.electrocompaniet.no
/