2. Holdrite
  3. QS-12-H

Holdrite QS-12-H Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Holdrite QS-12-H Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
®
CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONS
SM
Products shown may be protected by US Patent or have Patents Pending.
© 2012 HOLDRITE. All rights reserved. #LT66 - 05/12
QUICK STRAP
®
QS-5 AND QUICK
STRAP
®
QS-12
Step1: Orientmountingbracketvertically.
Locateandmark2mountingholesatleast
4”apart.Placeoneholeaboveupperstrap
slotsinbracketandtheotherholebelow
lowerstrapslots.
Step2: Drillpilotholesapprox.1-16”–3/32”
forincludedscrews.Forhollowwallor
concrete,installappropriateanchorsat
locationsmarkedinStep1(Fig1).Install
screwsoranchors.
Step3:Slidethestrapsthroughsideslotsin
bracket(Fig2),andpullabouthalf
waythrough.
Step4: Centerexpansiontankonbracket
aligningnotchinbracketwithribontank
(ifapplicable).Tightenstrapsaroundtank
with5/16”socket/nutdriver.Toavoid
damagingtank,donotover-tighten(Fig3).
INSTALLATION INSTRUCTIONS
Fig1
Fig2
Fig3
QUICK STRAP
®
EXPANSION
TANK MOUNTING BRACKETS
QUICK STRAP
®
EXPANSION
TANK MOUNTING BRACKETS
/