Rowenta CRIMPER WAVE Owner's manual

Page is loading ...

4

For your safety, this appliance complies with the technical rules and standards for safety

currently in force, including the Electromagnetic Compatibility and Low Voltage

Directives.

The appliance’s accessories become very hot during use. Avoid contact with the skin.

Make sure that the supply cord never comes into contact with the hot parts of the

appliance.

The appliance must be unplugged :

- before moving the plates,

- before cleaning and maintenance procedures,

- if it is not working correctly,

- as soon as you have finished using it,

- if you leave the room, even momentarily.

Check that the voltage of your electricity supply matches the voltage of your appliance.

Any error when connecting the appliance can cause irreparable harm, and will not be not

covered by the guarantee.

As an additional safety measure, we recommend the installation of a residual current

difference device in the electrical circuit supplying the bathroom, acting at not more than

30 mA. Ask your installer for advice.

Caution : Never use the appliance with wet hands or near baths, basins or other

recipients containing water.

When using the appliance in the bathroom, unplug it after use as the presence of water

nearby may pose a danger even when the appliance is turned off.

Close supervision is necessary when the appliance is used on or in the presence of

children or severely disabled people.

If the power cord is damaged, it must be replaced by the manufacturer, its after-sales

service or a person with similar qualifications, to avoid all danger.

Stop using your appliance and contact an Author ised Service Centre if :

- your appliance has fallen

- it does not work correctly.

If your appliance is not working correctly, see "Troubleshooting", or contact our Customer

Helpdesk or your dealer.

Do not leave within the reach of children.

Do not use if the cord is damaged.

Do not immerse or put under running water, even for cleaning purposes.

Do not hold with damp hands.

Do not hold the appliance by the casing, which is hot, but by the handle.

Do not unplug by pulling on the cord, rather pull out by the plug.

Do not use an electrical extension lead.

Do not clean with abrasive or corrosive products.

Do not use at temperatures below 0°C and above 35°C.

SAFETY PRECAUTIONS

GB

CF7013 038848 crimper 11/04/06 8:45 Page 4

5

Inserting the crimping

plates

Choose the plate (large crimping

– fig.1 or close crimping –

fig.2

) according to the effect

you want.

Press the lever to open the tong.

Insert the first plate by sliding it on

the groove until your hear a "CLICK "

- fig. 3.

Repeat the procedure with the

second plate.

Plugging in your hair

styler

Place the appliance in a stable

position on its rest on a flat surface.

Plug it in and set the On/Off

switch to On (position 1).

The 'Power on' light will come on

- fig. 4 and the accessory will

begin to heat up.

Wait a few minutes to allow your

hair styler to reach its working

temperature (10 min).

To remove the plates

When removing plates, always

hold them by the plastic

part – the metal parts will be very

hot.

Press the lever to open the tong.

Press the unlocking botton on the

first plate

– fig.5, then slide it to

remove it.

Repeat the procedure with the

second plate.

BEFORE YOU START

IMPORTANT

The ceramic coating protects

your hair from excessive

heat, thanks to an even

distribution of the heat.

1. Crimper

2. Accessory locking – and

unlocking – ring

3. Crimping plates with ceramic

coating : tight crimping

4. Crimping plates with ceramic

coating : large crimping

5. “Power on” light

6. On/Off switch (1-0)

7. Handle

8. Swivel power cord

DESCRIPTION

GB

CF7013 038848 crimper 11/04/06 8:45 Page 5

OPERATION

6

Unplug your styler and leave to

cool down.

Clean the crimper’s plates when

fully cooled.

To clean the handle, wipe with a

soft, damp cloth.

Never allow water or any other

liquid to enter the handle.

Do not use aggressive or

abrasive products.

Never put the appliance or

accessories under the running

water.

CLEANING

Your appliance is designed for

use in the home only. It should

not be used for professional

purposes.

Any commercial use, inappropriate

use or failure to comply with the

instructions, the manufacturer

accepts no responsibility and the

guarantee will not apply.

The guarantee becomes null and

void in the case of improper

usage.

GUARANTEE

Your appliance contains valuable

materials which can be recovered

or recycled.

Leave it at local civic waste

collection point.

ENVIRONMENT PROTECTION FIRST !

GB

Gather a section of hair

approximately 5 cm across,

starting at the root of the hair.

Press the lever to open the

crimper attachment, and place

the hair between the crimping

plates

- fig.6.

Close the crimping plates for

around 10 seconds.

Release the hair and start again

just below the wave just formed.

IMPORTANT

Use this product on clean,

untangled, DRY hair (to

avoid damaging your hair).

If you have any product problems or queries, please contact our

Customer Relations Team first for expert help and advice: 0845 602 1454

- UK (01) 4751947 - Ireland or consult our website -www.rowenta.co.uk

PROFESSIONAL TIPS

Always work from the roots towards the tips of the hair.

To enhance the effect, you can apply styling mousse before

crimping.

CF7013 038848 crimper 11/04/06 8:45 Page 6

Page is loading ...

Rowenta CRIMPER WAVE Owner's manual

Rowenta CRIMPER WAVE Owner's manual

in other languages

Related papers

Other documents