11 12
!
NEVER give this booster seat to someone else
without also giving them this manual.
!
NEVER use a second-hand booster seat or a
booster whose history you do not know.
!
DO NOT use this booster without the soft goods.
!
DO NOT use any load bearing contact points other
than those described in the instructions and
marked on the booster seat.
!
DO NOT face your booster toward the rear of the
vehicle.
!
To avoid burns, never put hot liquids in your
cupholders.
!
DO NOT use this child seat for more than 10 years
after the date of purchase, as parts may degrade
over time, or from exposure to sunlight, and may not
perform adequately in a crash.
!
The soft goods should not be replaced with any
besides the ones recommended by the manufacturer,
because the soft goods constitute an integral part of
the booster seat performance.
Emergency
In case of emergency or accidents, it is most important to have
your child taken care of with first aid and medical treatment
immediately.
Product Information
Read all the instructions in this manual before using
this product. If in doubt, consult either the booster seat
manufacturer or the retailer.
1. This booster is a ‘Universal’ booster seat. It is approved
to UN ECE regulation 44, 04 series of amendments, for
general use in vehicles and it will fit most, but not all, car
seats.
2. A correct fit is likely if the vehicle manufacturer has declared
in the vehicle handbook that the vehicle is capable of
accepting a ‘Universal’ booster seat for this age group.
3. This booster has been classified as ‘Universal’ under
more stringent conditions than those which applied to earlier
designs which do not carry this notice.
For Installation with Latch System and 3-point-belt
1. This booster is a ‘Semi-Universal’ child restraint. It is
approved to UN ECE regulation 44, 04 series of amendments
for general use in vehicles fitted with ISOFIX anchorages
systems.
2. It will fit vehicles with positions approved as ISOFIX
positions (as detailed in the vehicle handbook), depending on
the category of the booster and of the fixture.
3. If in doubt, consult either the booster manufacturer or
vehicle manufacturer.