FLUANCE.COM/SUPPORT
For additional product information, please consult the manual at:
QUICK START GUIDE
01
01
Get your new soundbase Get a sturdy table Place the Soundbase
on top of your table
02
Get your Soundbase
on your sturdy table Get your TV Place your TV on top
of your Soundbase
03
Optical Cable TV Inputs
Soundbase Inputs
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
• receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
IC warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement
changes or modifications not expressly approved by the party responsible for compliance
couldvoid the user's authority to operate the equipment.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment .This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Soundbase AB40
+
-
3D
STANDARD
BASS BOOST
X
SOUNDBASE
FLUANCE.COM/SUPPORT
For additional product information, please consult the manual at:
QUICK START GUIDE
04
Auxiliary Cable
(Auxiliary Cable not included)
Soundbase Inputs TV Inputs
05
+
-
3D
STANDARD
BASS BOOST
X
Once the volume is at its max the LED will blink twice.
Power
Mute
Virtual Surround Sound
ON/OFF
Standard Equalizer
Preset
Previous Track Skip Track
Play/Pause
Bass Boost
Source
Volume
Bluetooth
Power Volume
Source
Optical Aux Bluetooth
REMOTE
LED
This setup is optional as it is not required to set up the product
Power Cable
Soundbase Inputs Power Outlet
CONTROLS
-
1
-
2
Circus World Displays AB40 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI