Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.
Pack Contents
The following is included:
• Wine cooler
• Instruction manual
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
Note: If the appliance has been moved or stored in a non-vertical position, stand
it in an upright position for approximately 12 hours before operation. If in doubt
allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the wine cooler in direct sunlight or damp areas.
3. When positioning the wine cooler, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
4. If necessary, adjust the screw legs of the wine cooler to make it level.
Reversing the door
Depending on the location of the appliance, it may be necessary to change the direction the door of the
wine cooler opens by changing the side of the door handle.
To reverse the door handle:
1. Ensure the appliance is disconnected from the power
supply.
2. Tilt the appliance back slightly and prop it securely. The
appliance must not be tipped back by more than 45
degrees.
3. Unscrew the door hinge screws on the base of the door
and remove the Hinge.
4. Open the door slightly and remove the door in a
downward direction.
5. Remove the screw cover from the top of the wine cooler
with a small screwdriver.
6. Unscrew and remove the hinge from the top of the
appliance.
7. Screw the door frame Hinge to the opposite side of the
appliance and reattach the screw cover.
8. Fit the door into place by locating the upper Hinge first
then closing the door.
9. Reattach the Bottom hinge onto the opposite side of the
door.
10. The appliance can now be lowered into position.
Bottom Hinge
Screw cover Hinge