Burg-Wächter Nordic Mailbox Stand Operating instructions

  • Hello! I've reviewed the user manual for the BURG-WACHTER Nordic series letter boxes, including models 680, 780, 3680 Ni and 3780 Ni. The document provides detailed instructions on stand mounting and concrete embedding, ensuring proper alignment and installation. I'm ready to answer any questions you have about assembling and setting up your new letterbox.
  • What diameter drill is needed for the letter box?
    What is the purpose of the black half-round spacers?
    What should the stand pipes be parallel to?
    What angle should the stand be to the ground?
Letter boxes Nordic 680, 780, 3680 Ni and 3780 Ni
Stand mounting:
1. Drill the letter box through (Ø 5mm) at the pre-punched points in the side panels and deburr the drilled holes.
2. Slide the round pipe over the straight stand elements, so that the square holes are one above the other.
3. Insert the dowel into the holes as indicated in the figures.
4. Place the stand on its reverse side (ideally on a supporting layer, e.g. old carpet or cardboard). Place the box
with its rear side onto the stand.
5. Open the door (if necessary, an assisting person can secure it against closing). Insert the screws through the
holes from inside and use the black half-round spacers to screw them onto the stand (without tightening them
completely). Always begin with the holes positioned nearer to the box top panel.
I: (Dokumente)
\
Anleitungen
\
Briefkästen
\
Nordic
17.
12.2012 DIS
6. Proceed with tightening the screws while aligning the stand. The stand should run in parallel to the front edge
of the letter box.
7. The letter box is now ready to be embedded into concrete. While embedding it, the following needs to be
observed:
a. The stand pipes shall run in parallel to each other
.
b.
In all the directions, the stand shall be at a 90º angle to the ground.
c. The door gap shall be evenly spread, the stand shall not strain the letter box.
> 300 mm
Beton
Steine
verdichten
/