Robert Stevenson Lighting EC1243 Operating instructions
- Type
- Operating instructions
EC1221/EC1243
ASSEMBLY INSTRUCTIONS
Components List
Hardware List
ASSEMBLY STEPS
G
H
F
E
D
b
C
B
a
A
CAUTION - Refer to the wattage caution label located near the socket for maximum wattage rating-do not exceed
maximum wattage listed.
1.Remove fixture and components from the packaging.
2.Install the mounting bracket (B) onto the wall by using appropriately sized long screws (a).
3.Connect the Ground wire from the fixture and canopy to junction box, secure the electrical connections using the wire
connector (A). Connect the NEUTURAL (OR WHITE) WIRE from the fixture to WHITE NEUTRAL WIRE from power supply
with the wire connector (A). Connect the HOT (OR BLACK) WIRE from fixture to BLACK SUPPLY WIRE from power supply
with the wire connector (A).
4.Mount Canopy (C) without glass onto Mounting Bracket (G) using 3 Flathead Screws (b).
5.Install each glass (G) onto the socket (H) and secure with Socket Collar (D) until tight.
6.Install desired Light Bulb.
WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO TURN OFF MAIN POWER PRIOR
TO INSTALLATION.
a
A Wire connector 3
Mounting bracket 1
Canopy 1
Socket Collar
3
Fixture Body
1
Item Description Quantity Item Description Quantity
Item Description QuantityItem Description Quantity
Long screw (1”) 2
Flathead Screw
3
B
C
D
E
F Bulb (Not included) 3
Glass 3
Socket 3
G
H
I
J
b
Note: (1). The above diagram is an illustration of mounting components and steps. This is a representative
drawing and may not exactly match the style of your fixture.
-
1
Robert Stevenson Lighting EC1243 Operating instructions
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI