2. Lantech
  3. POS-100A

Lantech POS-100A User manual

  • Hello, I have reviewed the Quick Installation Guide for the Lantech PoE Splitters: POS-100A, POA-100B, and POA-1000A. This document describes setting up and connecting the devices using Ethernet cables, how to choose a proper DC jack size and connect to a powered device. I'm ready to answer any questions you have regarding installation or troubleshooting.
  • What voltage options are available on the PoE splitter?
    How do I know if the splitter is powered on?
    What should I do if the powered device is not working?
POS-100A / POA-100B / POA-1000A
Quick Installation Guide
Package Content
Quick
Installation
Guide
PoE Splitter x 1,
DC jack cable x 1,
Ethernet cable x 1
4 DC jack cable
connector
PoE Injector x 1
Power Cord x 1
Installation Steps
1. Connect AC Power cord to PoE injector, and “Power” LED will be lit.
2. Connect Data/IN port of Injector to LAN switch via Ethernet cable, and set the correct voltage (5V or
9V or 12V) (default 5V) via voltage selector on the side of PoE splitter.
3. Connect to “Power+Data” port of splitter and “P+D/Out” port of Injector with Ethernet cable, making
sure “Power” LED of splitter is lit.
4. Select the proper DC jack size for the cable, then connect power jack of the powered device to
“Power OUT” port of splitter.
5. Check whether the powered device is on. If not, please make sure that power of Injector and Splitter
is on, and all cables are well connected.
/