Kohler 2971-KS-NA Dimensions Guide

  • Hello! I am an AI chatbot trained to assist you with the Kohler 2971-KS-NA Dimensions Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Features
Pressure-balance diaphragm technology provides reliable anti
scald protection and maintains mixed water temperature within
+/- 3 degrees Fahrenheit.
Maximum flow rate of 13.0 gpm at 45psi - ideal for multiple
outlet shower installations or rapid bath filling.
3/4-inch NPT connections.
Integral shut-off valve stops.
Adjustable high-temperature limit stop to control maximum
temperature.
Deep rough-in kits are available – refer to individual trim design.
Requires valve trim (sold separately).
Material
Forged brass construction.
Installation
Codes/Standards
Cartridge is reversible for installations where hot and cold
supplies are reversed.
ASME A112.18.1/CSA B125.1
ASSE 1016/ASME A112.1016/CSA B125.16
ADA
Requires K-9663 twin ell (sold separately) when using a diverter
spout.
KOHLER
®
Faucet Lifetime Limited
Warranty
Recommended Accessories
88526 Thin Wall Trim Kit
See website for detailed warranty information.
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
2-18-2018 01:55
Rite-Temp
®
3/4" Pressure-balancing Valve
K-2971-KS
3/4" NPT
Cold Inlet
Finished
Wall
2-3/16"
(56 mm)
3/4" NPT
Hot Inlet
2-1/4" (57 mm)
Thin Wall
2-3/4" (70 mm) Min
3-1/2" (89 mm) Max
Thick Wall
6"
(152 mm)
8" (203 mm)
1/2"
(13 mm)
3/4" NPT
For 3/4" Nom.
Copper Tubing
Notes
Technical Information
Install this product according to the installation
guide.
All product dimensions are nominal.
Shower Valve:
CAUTION: Risk of product damage. When using
this valve in a fiberglass or acrylic installation,
15 psi (1 bar)Min. pressure IN:
use the thin wall installation kit 88526 (sold
separately).
For installations with a diverter spout, a twin ell,
K-9663 (sold separately), is required between the
valve and the spout.
Avoid cross-flow conditions. Do not install shut-off
device on either valve outlet.
ADA compliant when installed to the specific
requirements of these regulations.
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
2-18-2018 01:55
Rite-Temp
®
3/4" Pressure-balancing Valve
K-2971-KS
/