WAC Lighting Cable Power Feed Operating instructions

Brand: WAC Lighting

Model: Cable Power Feed

Type: Operating instructions

12/01/03 REV 1

INSTRUCTIONS: Cable Power Feed

Models: LM-PCS 48” & LM-PCS96”

CAUTION:

Always turn off power at main switch prior to installation to prevent electrical shock.

Have wiring checked by a qualified electrician.

Overview:

The power feed canopy is designed to fit over a

standard 4” junction box, or may be fed from conduit,

or surface wiring. Power is supplied from a remote

transformer.

1. On the power feed canopy, loosen the three

canopy screws and separate the canopy from

the base plate.

2. Remove a knock out from the base plate.

3. Pull several inches of wire through the knock

out hole.

4. Attach the base plate to the junction box using

two screws from the box (or use mounting

screws supplied for direct mounting to a

surface).

5. Raise the canopy to the base plate.

6. Connect to the two wires from the transformer

to the canopy wires with wire nuts (supplied).

7. Fit the canopy to the base plate, and tighten

the three screws loosened earlier.

8. Loosen the setscrew on the rail adapter so that

the two pieces will slip over the rail.

9. Hold the two adapter halves against the rail

while tightening the setscrew. It is important

that the adapters halves seat firmly against the

rail.

10.

fter the first 20 minutes of operation switch off

system and check for abnormal heat. Hot spots

are caused by poor connection, correct by re-

tightening.

Base plate

Canopy

Cables

Adapter halves

Rail

Adjusting Wire Length:

1. Remove the setscrew holding the adapter halves,

and separate the halves.

2. Loosen the small setscrews located on the inside

surface of each half, using a 1/16” Allen wrench.

3. Withdraw wires and trim to desired length. Strip

3/8” insulation from wire ends.

4. Attach a brass crimp fitting to the end of each

wire.

5. Reassembly is the reverse procedure.

6. The rubber insulator should be positioned so it

does not protrude into the rail space.

7. Important: Make sure the clear rubber washer

remains in place in the recess of the setscrew

used to secure adapter halves.

Retain instructions for future reference.

Wires from a transformer

Screw recess

WAC Lighting Cable Power Feed Operating instructions

WAC Lighting Cable Power Feed Operating instructions

WAC Lighting Cable Power Feed Operating instructions

Other documents