Zhongshan Miaowang Electrical Appliance EGGA01 User manual

Brand: Zhongshan Miaowang Electrical Appliance

Model: EGGA01

Type: User manual

The Zhongshan Miaowang Electrical Appliance EGGA01 is a ceiling fan and lamp remote controller that allows you to control your fan and light from the comfort of your couch. It features 3 fan speeds, a timer function, and adjustable light brightness. It is easy to install and use, and it comes with a pre-programmed syncing process for quick setup.

CEILING FAN LAMP REMOTE CONTROLLER

USER MANUAL

ATTENTION!

DO NOT USE THIS FAN WITH A DIMMER SWITCH OR VARIABLE SPEED WALL CONTROL.USING A

DIMMER SWITCH OR VARIABLE SPEED WALL CONTROL WILL DAMAGE THE FAN.

This remote is pre-programmed from the factory and should work right out of the box once the battery is

installed.Should,for any reason,reprogramming be needed,please follow the syncing process as follow:

SYNCING INSTRUCTIONS:

Turn off the main power,then turn it back on.Within 10 seconds,press and hold the high and low speed

buttons on the remote at the same time for 3 seconds.The LED indicator will fash 1 times,signaling a

successful synchronization.Once complete,the fan will start on the low speed with the light(if applicable)

off.

①Input Livel Wire(Black Line)

② Input Neutra Wire (White Line)

③Output Neutral Wire(White Line)

④ Connection Motor Live Wire(Black

Line)

⑤ Connection Lamp Live Wire(Blue Line)

① Fan Speed Controlle

② Motor Switch

③ Lamp Switch

Battery Replacement: 3A/1.5V

Motor live wire L

(black)

Share neutral wire N

(white)

Light live wire L

(blue)

Motor live wire L

(black)

Share neutral wire N

(white)

Light live wire L

(blue)

Power live wire(black)L

Power neutral wire(white)N

Hanging bracket

Ground wire (Green) E

Receiver

Fan Speed

Fan Timer Switch

Fan OFF

Light brightness +/-

Light Control ON/OFF

“NO LIGHT”no effect

FCC Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Zhongshan Miaowang Electrical Appliance EGGA01 User manual

Brand: Zhongshan Miaowang Electrical Appliance

Model: EGGA01

Type: User manual

Download PDF

report

Zhongshan Miaowang Electrical Appliance EGGA01 User manual

Zhongshan Miaowang Electrical Appliance EGGA01 User manual

Other documents