DirekTronik 20109708 Owner's manual

  • Hello! I'm your assistant, and I've reviewed the user manual for the DIREKTRONIK Horn Speaker GJD191. This manual details the specifications, installation, and important notes for the speaker, which is designed for use with amplifiers having an 8 Ohm output impedance. It's suitable for outdoor use if protected from water and has a frequency range of 600-7000 Hz. I'm ready to answer your questions about it.
  • What is the maximum power rating of the horn speaker?
    What is the impedance of the horn speaker?
    What is the frequency range of the horn speaker?
    What type of sealant should be used for cable entry?
HORN SPEAKER
GJD191 Horn Speaker for Multispeech 4
WARNING
• NYLON WASHERS PROVIDED MUST BE USED WITH
SCREWS
• ENSURE CABLE ENTRY AND SCREW HOLES ARE
SEALED WITH WATER BASED SEALANT
• DO NOT USE SILICONE BASED SEALANT
-1-
INTRODUCTION
The horn speaker is specially designed for use with
ampliers with an output impedance of 8 Ohms or
less. Due to the humidity - protected ABS housing
the speaker is also suitable for outside applications
provided that it is protected against dripping water,
splash water, and precipitation.
PACKAGE CONTENTS
The package contains:
• 1 x Horn Speaker
• 1 x Installation Guide
INSTALLATION
• The Horn Speaker can be mounted on a at surface
by tightly screwing through the holes on the base
plate.
• For horn alignment, loosen the xing nut on the
mounting plate and adjust the horn to the required
position. Re - tighten the nut once the desired
position is achieved.
• Ensure that there is no power to the Multispeech
4, then connect the speaker to the amplier output
ensuring correct polarity.
IMPORTANT NOTES
• When using multiple speakers, ensure that the
polarity of each speaker is the same and also that
the output impedance of the amplier will not fall
below the admissible value.
• When cleaning the horn speaker, use a soft cloth
(dry or slightly damp). Never use aggressive
detergents or chemical as they may harm the unit.
• If the speaker is to be put out of operation
permanently, take it to a local recycling centre which
is not harmful to the environment for disposal.
Power Rating 15 W Max, 8 Ohm
Frequency
Range
600 - 7000 Hz
SPL (1 W/1 M) 104 dB
Dimensions 135mm x 135mm x 165mm
Weight 380g
Mounting Mount on a secure at
surface.
Certications
SPECIFICATIONS
ENGINEER NOTES
Technical: 01706 363990
Sales: 01706 363998
Fax: 01706 363991
Unit 2, Birch Business Park, Whittle,Lane,Heywood,OL10 2SX
/