Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Care and maintenance
1
• Check you have all the
components and tools listed on
page 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Assembly Instructions
Open Table
6
To release Safety lock
To secure Safety lock
1
2
3
1 2
3
SAFETY LOCK INSTRUCTION.
Unfold apron of leaves
Release safety locks
(see safety lock instruction
below) Hold the apron of
table to lift the table up and
pull the table tops out as
shown by the arrows.
a:
a:
b:
Make sure left and right
side top and extension
leaves are flat and aligned.
b:
Hold the apron of table
to push on both sides of
tables as shown by the
arrows. Use safety locks
to ensure table tops will
not move while using.
(see safety lock instruction
below)
c:
c:
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• Dispose of all packaging
carefully and responsibly.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts.
• Reguraly check and ensure
that all bolts and fittings are
tightend properly.