Juice dispenser
MODEL: 468001
USER MANUAL
Stalgast sp. z o.o. ul. Staniewicka 5 03-310 Warszawa
Thank you for your purchase of a Stalgast product. Before use please familiarize yourself in detail with the following instruction
manual.
Copying of the following manual without the consent of the manufacturer is prohibited.
Images and drawings are of illustrative character and may differ from the purchased product.
Attention: This manual should be kept in a safe place accessible for personnel. The manufacturer reserves the right to
change the technical characteristics of the product without any notice.
1. SAFETY INSTRUCTIONS
• Incorrect maintenance and/or use may cause serious harm to people and damage the device.
• The device can only be used for the purpose for which it has been designed.
• The manufacturer does not take any responsibility for damages caused by improper maintenance or use of the device.
Failure to obey these instructions may cause life threatening danger.
• Use of the device by people underage, physically or mentally incapable, with motion disorders as well as people without
proper experience and knowledge regarding the use of this device should not be allowed. All of the above should only use
the device under supervision of a person responsible for their health and safety.
2. REMARKS
• Hot uids are not allowed to be used in this dispenser (over 60 °C). Hot uids may damage the device
• This device cannot be washed in a dishwasher
3. STRUCTURE OF THE DEVICE
3.1. Intended purpose of the device
This device is designed to dispense juice and other non-carbonated beverages.
3.2. Description of the device
A
B
Fig. 1
1. Tank lid
2. Ice container
3. Fluid container
4. Base with rubber feet
5. Drip tray
6. Tap
A – juice container
B – Ice container
- 2 -
4. TECHNICAL SPECIFICATION
Dimensions WxDxH 265x350x560 mm
Capacity of the tank 8 liters
5. ASSEMBLY
5.1. Placing the device
This device should be set on even and stable surface
6. OPERATING THE DEVICE
Before using the device clean it in accordance with point 7 Cleaning and Maintenance.
In order to ll the tank lift the lid, then ll the A part (g.1) with liquid and place the lid back on the tank.
Place the container to which liquid from the tank is to be dispensed on the drip tray. Pull the lever on the tap. In order to stop
the ow of liquid release the tap lever.
A designated container for ice allows for the stored liquids to be chilled. In order to place ice in the container lift the lid and ll
the B part of the tank with ice. Do not overll the tank.
7. CLEANING AND MAINTENANCE
The beverage container should be washed after each use and after it has remained unused for an extended period of time.
Do not use abrasive or corrosive agents to clean the container.
The device can be washed under running water with the use of a soft cloth and some dish washing detergent.
After washing all elements of the dispenser should be wiped dry.
8. END-OF-SERVICE LIFE RECYCLING
After the device reached its end-of-service life or when buying new equipment at Stalgast you can return the old device. Send
it to us and a specialized company will recycle it in accordance with the ESOL for Electrical and Electronic Equipment Act
(Legal Journal 2005 no. 180 point 1495).
9. WARRANTY
The seller provides warranty for the product.
Any damage resulting from settlement of calcium on the device is not covered by the warranty.
Such elements as light bulbs, rubber elements, heating elements damaged by limescale, screws and elements which naturally
wear down such as heaters, gaskets, and any other elements damaged mechanically are not covered by the warranty.
/
