AEK1700
Aztech Electric Kettle
USER MANUAL
PLEASE RETAIN THIS USER MANUAL FOR FUTURE USE.
SAFETY INSTRUCTIONS
This product has been designed for domestic use only.
The manufacturer will not take any responsibility if a
misuse or a failure
of complying with the instructions provided in this user manual was
the issue.
Before you connect the kettle to the power supply, make sure that the
voltage indicated on the rating plate located at the bottom of the
kettle matches the mains voltage in your home. If it does not match,
contact your dealer and do not use the kettle.
Ensure that the appliance is placed on a rm and at surface. Do not
put it on the edge of a table or bench.
Always hold your appliance by its handle, since the outer surface may
be hot.
Do not open the lid while the kettle is in use.
Do not lift the lid while boiling water in the kettle.
Do not ll the kettle above the MAX level (1.7L). Boiling water may
splash out of the kettle if overlled.
Never immerse the kettle or its cord in any kind of liquid. Do not allow
liquid to penetrate the electrical parts of this kettle.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons in order
to avoid a hazard.
Do not repair the device yourself, but rather consult an authorized
expert.
Your kettle must only be used with its attached lid and the power
base supplied with it.
The Electric Kettle has a Boil-Dry feature which automatically turns off
the appliance if you accidentally switch it ON without any water. If
this occurs, allow the Electric kettle to cool down rst before lling it
with cold water.
Cleaning and user maintenance SHOULD NOT BE MADE by children
unless they are OLDER THAN 8 and SUPERVISED. Keep the appliance
and its cord safe and out of reach from children aged less than 8
years old.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
PACKAGE CONTENTS
1) Aztech AEK1700
2) 360
O
Gyral Base
3) User Manual
ELECTRIC KETTLE FEATURES
1
2
3
5
4
6
Spout and Filter
Lid Release Button
Water Window and
Label
Handle
360
O
Gyral Base
ON/OFF Switch with
Power Indicator Light
1.
2.
3.
4.
5.
6.
FOUR STEPS IN BOILING WATER
STEP 1: Position Your Electric Kettle
Position the power base on a smooth,
at and dry surface.
The underside of the power base is
tted with a cable storage feature.
Unwind the length of the cord
required to reach the power outlet.
a.
b.
BEFORE USE
Before rst use, ll the kettle with cold water to the MAX water
level mark, bring to boil and discard boiled water TWICE. This
will ensure that residues left from the manufacturing process are
completely removed before using it for drinking.
4) Easy Start guide
5) Warranty Policy
STEP 2: Position Your Electric Kettle
Lift the kettle from the power base
and press the lid release button to
open the lid.
Fill the kettle with cold water
between the MIN and MAX markings
on the water level indicator through
its opening or its spout.
Close the kettle’s lid and place the
kettle back to its power base. Make
sure the lid is securely closed.
a.
b.
c.
With the kettle’s lid open, gently pull
the lter out of its retaining slot and
lift the lter out of the kettle.
Rinse the lter with warm water and
gently remove any attached scales
using a soft brush.
After rinsing, gently slide it down into
its slot until it clicks into place.
a.
b.
c.
STEP 3: Switch in ON
To start boiling, press the ON/OFF switch
down to “I”(on) position. The power
indicator will light up and the kettle will
start to boil.
STEP 4: It will AUTOMATICALLY
TURN OFF
The Electric Kettle automatically turns OFF
after boiling. You may also stop it from
boiling by lifting the ON/OFF switch to “0”
(off) or by lifting the kettle away from its
power base.
KETTLE CARE AND CLEANING
Cleaning the Filter
/
