ART 481/A+

Whirlpool ART 481/A+, WSE 2930 X, WSF7256 A+IX Program Chart

  • Hello! I am an AI chatbot trained to assist you with the Whirlpool ART 481/A+ Program Chart. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How do I activate or deactivate the appliance?
    What do the three green lights indicate?
    How do I set a different refrigerator compartment temperature?
    What is the Super Cooling function?
    How do I activate the Super Cooling function?
    How long does the Super Cooling function stay active?
    What are the temperature settings?
    What should I do if there is a power supply problem?
    What should I do if the appliance is in Off mode?
    What should I do if the light is not working?
What to do if... Possible causes: Solutions:
The control panel is switched off, the appliance does not work.
There may be an appliance power supply problem.
The appliance could be in off mode.
Make sure:
- there is not a power outage
- the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position
(i.e. allows the appliance to be powered)
- the household electrical system protection devices are efficient
- the power cable is not broken.
Activate the appliance with the On/Off button
The inside light does not work. The light may need replacing.
Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a
new one (see the section "Lamp or LED replacement").
Models with LED lights: contact the authorised Service Centre.
The temperature inside the compartments is not low enough. There could be various causes (see "Cures")
Make sure:
- the doors close properly
- the appliance is not installed near a heat source
- the set temperature is adequate
- the circulation of air through the vents at the bottom of the appliance is not obstructed
There is water on the bottom of the refrigerator compartment. The defrost water drain is blocked. Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning")
The front edge of the appliance, at the door striker seal, is hot This is not a defect It prevents condensate from forming. No cure is necessary.
One or more green lights flash continuously.
Malfunction alarm
The alarm indicates a fault in a technical component.
Call the authorised Service Centre.
Refrigerator Compartment
A. Fan and antibacterial and antiodour filter (if available)
B. Lamp or LED light (depending on the model)
C. Shelves
D. LED lights (depending on the model)
E. Special Compartment cover ("Meat & Fish" or "Zero
Degrees") (if available)
F. Special Compartment ("Meat & Fish" or "Zero
Degrees") (if available)
G. Crisper cover
H. Crisper(s)
I. Rating plate (located at side of crisper)
L. Control panel
P. Dairy compartment
Q. Door trays
R. Bottle holder (if provided)
S. Bottle shelf
Least cold zone
Intermediate zone
Coldest zone
Fruit&veg zone
Freezer Compartment
M. Top drawer or door (freezing zone)
N. Middle and bottom drawers (frozen and deep-frozen
food storage zone)
O. Ice cube tray (if provided)
Note: All shelves, door trays and racks are removable.
The ideal food storage temperatures are already factory-
set.
Before using the appliance, also carefully read the
instructions provided with it.
The characteristics, technical data and images may
vary according to the model.
Super Cooling
Press the "Temperature Fast Cool" button for 3
seconds before putting large amounts of fresh food in
the refrigerator compartment.
When the function is active, the yellow light is on and
the three green lights are off.
This function is automatically deactivated after 6
hours, or manually by pressing the button again for 3
seconds.
When the function is not active, the yellow light is off
and the indication of the set temperature is shown by
the green lights.
On/Off
Press to activate/deactivate the appliance.
Note: This operation does not disconnect the
appliance from the power supply
Refrigerator compartment temperature
The three green lights indicate the set refrigerator
compartment temperature.
A different temperature can be set using the
"Temperature Fast Cool"
button.
The following adjustments are possible:
LED's on Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
QUICK GUIDE
GB
LVESTLT
5019 308 01055
Printed in Italy 01/12 - Whirlpool
®
Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2012. All rights reserved - http://www.whirlpool.eu
/