ATN Extended Life Battery Quick start guide

Type
Quick start guide

ATN Extended Life Battery

ATN Extended Life Battery is a rechargeable 10,000 mAh battery that can be used to power your ATN Binocular or Monocular. It comes with a Neck/Shoulder strap to attach to your device, and a USB to USB type C Cable for charging.

The battery can be charged for at least 10 hours before first use. You can use your computer or a compatible wall charger (not included) to charge the battery.

To use the battery, simply insert the USB cable into the battery and press the power button. Then, place the battery in the Neck/Shoulder strap battery compartment and close the zipper.

ATN Extended Life Battery

ATN Extended Life Battery is a rechargeable 10,000 mAh battery that can be used to power your ATN Binocular or Monocular. It comes with a Neck/Shoulder strap to attach to your device, and a USB to USB type C Cable for charging.

The battery can be charged for at least 10 hours before first use. You can use your computer or a compatible wall charger (not included) to charge the battery.

To use the battery, simply insert the USB cable into the battery and press the power button. Then, place the battery in the Neck/Shoulder strap battery compartment and close the zipper.

QUICK START GUIDE
UNPACKING
When opening your package make
sure that all the contents are present.
You should see a rechargeable 10,000
mAh battery, a Neck/Shoulder strap to
attach to your Binocular or Monocular,
plus the USB to USB type C Cable.
NOTE:
We recommend charging the
battery for at least 10 hours before
use. You can use your computer
or a compatible wall charger (not
included), to charge the battery
initially.
The information in this manual is furnished for informational use only, is subject to change without notice,
is not to be construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.
©2020 ATN Corp. All rights reserved.
EXTENDED LIFE
BATTERY PACKAGE
STEP 1
Take the USB to USB type C cable
and insert it into the provided opening
at the end of the Neck/Shoulder strap
as shown in the image.
Pull the cable all the way through
until it reaches the center of the Neck/
Shoulder strap battery holder com-
partment.
STEP 2
Attach the Neck/Shoulder strap to
your ATN Binocular or Monocular by
taking one end of the strap and loop-
ing it through the provided slot on the
body of the device. As illustrated.
Loop the strap and insert it into the
plastic fastener.
Pull the strap through the plastic
fastener and make sure it goes all the
way through the other side of the fas-
tener.
Adjust the strap so it is tight and
does not slip off, when you wear the
binocular or monocular on your neck
or shoulder.
STEP 3
Insert the USB cable into the re-
chargeable battery.
Press the power button on the
BATTERY” before placing the battery
in the Neck/Shoulder strap battery
compartment.
Once the battery has been activat-
ed, place it in the provided battery
compartment in the center of the
Neck/Shoulder strap and close the
zipper.
For customer service and technical support, please contact
American Technologies Network Corp.
1341 San Mateo Avenue, South San Francisco, CA 94080. Phone: 800-910-2862, 650-989-5100; e-mail: service@atncorp.com
www.atncorp.com
©2020 ATN Corporation
STEP 5
You are now ready to turn “ON” your
device using the external battery pack
as a power source. Press the “POW-
ER” button on your device to boot up
the system.
STEP 4
Lift the rubber media port to expose
the media slots.
Insert the USB type C plug in to the
USB type C media port.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

ATN Extended Life Battery Quick start guide

Type
Quick start guide

ATN Extended Life Battery

ATN Extended Life Battery is a rechargeable 10,000 mAh battery that can be used to power your ATN Binocular or Monocular. It comes with a Neck/Shoulder strap to attach to your device, and a USB to USB type C Cable for charging.

The battery can be charged for at least 10 hours before first use. You can use your computer or a compatible wall charger (not included) to charge the battery.

To use the battery, simply insert the USB cable into the battery and press the power button. Then, place the battery in the Neck/Shoulder strap battery compartment and close the zipper.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI