8” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
2
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
8 INCH WALL
BRACKET
MAST B
SWAGED
END
MAST A
MAST B
MAST A
LAG
SCREW
LAG
SCREW
CLAMPING
SCREWS
Select a location that will provide the highest,
unobstructed position for the wind sensors.
3
MAST
7/16”
HAMMER
TAPE MEASURE
7/16” WRENCH
3
8
/ ”
3/8” WRENCH
TOOLS
REQUIRED
DRILL WITH
1/8” DRILL BIT
SLOTTED SCREW
DRIVER
PHILLIPS SCREW
DRIVER
LEVEL
BRACKET WILL
ACCOMMODATE
UP TO 8 INCH
OVERHANG OF EAVE
8” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 2
1/8” PILOT
HOLES
4
Drill two 1/8” level pilot holes 6” apart for each
bracket. Brackets must be separated from each
other by at least 18” for mast stability. Both
brackets must be aligned vertically for the mast
to be straight when installed.
5
Secure the brackets
with the lag screws
6
Slip mast into brackets and tighten
with the clamping screws.
CLAMPING
SCREWS
8 INCH
BRACKET
8 INCH
BRACKET
MAST
PILOT
HOLES
LAG
SCREWS
8 INCH
BRACKET
ROOF
PEAK
6”
18”
MINIMUM
LEVEL
ROOF
PEAK
/
