Page is loading ...
Note: In circumstance of changing position, pairs must be untied in reverse order (5→ 1) and moved to prearranged location one by one, then
refrigerator and freezer products should be installed in sequence (1→5) once again .
7
S3
4
7
7
5. Insert connecting clip strip (7) between the refrigerator and
freezer products, with a narrow gap to front connecting board
cover (4) and matching the top cover block (S3) .
4
6
3
S2
4. Remove adhesive taps (S2). Assemble front connecting board (3)
with screws (6) on the front of the products. Then assemble front
connecting board cover (4) on the front connecting board (3).
1
2
3. Assemble up connecting board (1) with screws (2) on the top of
the products.
15
2. Assemble up connecting board (1) with screws (5) on the back of
the products.
S1
1. Firstly, refrigerator and freezer products must be leveled. If
required, turn the adjustable bottom feet part (S1) clockwise to
raise the unit and counterclockwise to low it.
765
4321
Required tools
≥ 75mm
2055mm
1220mm
≥ 50mm5mm≥ 50mm
Reference Dimension
Installation in pairs
/
