Brandt KIT185X Owner's manual

Note: In circumstance of changing position, pairs must be untied in reverse order (5→ 1) and moved to prearranged location one by one, then

refrigerator and freezer products should be installed in sequence (1→5) once again .

5. Insert connecting clip strip (7) between the refrigerator and

freezer products, with a narrow gap to front connecting board

cover (4) and matching the top cover block (S3) .

4. Remove adhesive taps (S2). Assemble front connecting board (3)

with screws (6) on the front of the products. Then assemble front

connecting board cover (4) on the front connecting board (3).

3. Assemble up connecting board (1) with screws (2) on the top of

the products.

2. Assemble up connecting board (1) with screws (5) on the back of

the products.

1. Firstly, refrigerator and freezer products must be leveled. If

required, turn the adjustable bottom feet part (S1) clockwise to

raise the unit and counterclockwise to low it.

765

4321

Required tools

≥ 75mm

2055mm

1220mm

≥ 50mm5mm≥ 50mm

Reference Dimension

Installation in pairs

This manual is also suitable for

Download PDF