Palsonic PW411SFZR Owner's manual

Type
Owner's manual
PW411SFZR
PW411SFZL
411 Litre Frost Free Switchable /
Hybrid Refrigerator or Freezer
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
WARNING:
-WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in
structure, clear of obstruction.
-WARNING: Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
-WARNING: Do not damage the refrigerant circuit.
-WARNING: Do not use electrical appliances inside the food storage compartments
of the appliance, unless they are of the type recommended by the manufacturer.
-Do not store explosive substances such as aerosol cans with a flammable propellant
in this appliance.
This appliance is intended to be used in household and similar applications such as
staff kitchen areas in shops, offices and other working environments;
farm houses and by clients in hotels, motels and other residential type environments;
bed and breakfast type environments;
catering and similar non-retail applications.
Energy Saving Tips
· The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
· Let hot foods cool to room temperature before placing in the appliance.
Overloading the appliance forces the compressor to run longer. Foods that freeze too
slowly may lose quality, or spoil.
· Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.
· Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less
efficient.
· Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
1
PROPER USE OF REFRIGERATOR
l Before the use of the fridge, remove all packages, including bottom cushion and foam pads
and rubber belts in the fridge;
l Clear the outside and inside of the fridge with a piece of warm wet rag (little detergent can
be added into the warm water. Clear the fridge with fresh water at last);
l Prepare a separate two-pole grounding receptacle.
Do not share a multi-socket with other electric appliances.
l The ground wire must be well connected and the grounding pole of the receptacle should be
grounded reliably.
l Open the door, take out the attachments (the bottom decorative cover), and three setscrews
in the bag of the instruction. And install it onto the bottom beam of the fridge. For operation
method, see the right diagram.
Transport and placement of fridge
Transport
l Do not invert, place horizontally, squeeze or shock the fridge. And the declination angle of
the fridge must be no more than 45
° when moving.
l When moving, do not force too much on the door or top for fear of deformation.
Placement
l Place the fridge at a well-ventilated place and keep it away from heat and direct sunshine.
Never put it at a damp or watery place, for fear of rusting or weakening the insulation.
l The top clearance outside the fridge must be no less than 30cm, and the clearance from both
sides and back to the walls must be no less than 10cm for the convenience of opening and heat
emission.
l Put the fridge on the flat and solid ground. (adjust the adjustable legs to get balance if
unstable).
Standing
l Do not switch on the fridge immediately after vertical placement. Only switch it on after 6
hours' standing to ensure its proper operation.
Notice
To prevent damage to the power cord and any consequent incidents, the power cord should
not be covered by the fridge or other objects.
Before switching on the fridge, please check carefully whether the voltage range of the fridge
is the same as that of the power supply.
2
INSTALL THE DOOR HANDLE
Note: Figures in the user manual are only for reference. The actual product may
differ slightly.
The refrigerator must be disconnected from the source of electrical supply before
attempting the installation of accessory.
NOTE:the screws and wrench are in the plastic bag.
3
take out the two crisscross-screw;and install them into the door holes;
turn the screws till to the bottom;
aim at screws to install the handle;
the screws in the hole at the side of the handle and turn the screws till
them very tight.
the hole
the scr ew
5o
PS: If we change some small parts of the refrigerator , it is for you to
use it more conveniently. Sorry for no giving notice.
utlet airflow gap
6inlet airflow gap
9
10wire drawer
wire drawer
wire door tray
1lamp switch
2lamp cover
3 temperature sensor gap
Note: Figures in the user manual are only for reference. The actual
product may differ slightly.
4 wire freezer shelf
8door tray
7
4
PARTS LIST
INSTALL THE DECORATIVE COVER FOR BOTTOM BEAM
lOpen the door, take out the attachments (the bottom decorative cover), and three
setscrews in the bag of the Instruction. And install it onto the bottom beam of the fridge.
For operation method, see the below diagram.
Screws
Decorative cover for bottom beam
Install the bottom decorative cover using screw as below pictures.
cover plate
get rid of the cover plate on the side of
the hinge and keep the one on the
other side.
The opposite side on the hinge
is kept and fixed to be level.
get rid of the cover plate on
the side of the hinge
The opposite side on the hinge
is kept and fixed to be level.
get rid of the cover plate on
the side of the hinge
5
6
SAFETY PRECAUTION
7
POSITIONING
100mm
100mm
300mm
Install this appliance in an area where the
ambient temperature is between 110 (43)
and 32 (0).If the temperature around the
appliance is too low or high ,cooling ability may
be affected
30 minutes later,open the freezer
compartment door ,feel the cold air,that means
the unit works properly.
After a period of time to set the freezer
temperature at the desired temperature.
(Set the range from -14 ~-22 ( )) 7 ~ -8
8
OPERATION CHECK
back side
air gap
9
FOOD STORAGE
INTRODUCTION OF THE FUNCTIONS
1 2
FE
A B C D
1Alarm lamp
1.Hi-Temp(High temperature alarm)
2.
Door Open(Door keep open for 60 seconds alarm )
3 Funtion
A.Quick Freeze button B.or temperature switch button
C.Alarm Reset button D.Lock/Unlock button
2Button
E.Temperature / Quick Freeze time setting ( ) downsetting
F.Temperature / Freeze time setting ( ) upsetting Quick
Refrigerator and Freezer temperature setting
G
Press button E or F can easily realize the switching function of Refrigerator and
Freezer.the temperature icon G flickering, set the temperature range as follows
-24-23 -22 -13 -122 67 8or 8
76 2 -12-13 -22 -23 -24
-11 -10 -9 1036 44 45 46 or 46 45
44 36 10 -9 -10 -11
Exits the setting state 10 seconds later and takes effect.(when the temperature adjust,
also can press button D to lock and the temperature setting effect).
WARNING:
Please remove the food from the cabinet before switching the function of
Refrigerator and Freezer.
When adjust the temperature, please pay attention to the real adjusted
temperature for avoiding a mistake that the function directly from
Refrigerator to Freezer or from Freezer to Refrigerator while not remove
the food.
10
INTRODUCTION OF THE FUNCTIONS
Temperature or mode
Press button B to switch the freezer temperature show; easily to switch
between and mode.
Alarm cancel
Press button C to cancel buzzing alarm when freezer high temperature alarm.
Lock/Unlock
Unlock mode:press button D for 3 seconds to lock; after lock all button are inefficacy
except button D.
Lock mode:press button D for 3 seconds to release ;
When setting temperature and quick freeze time,press button D to exit and setting effect.
Please contact the after-sales Service Department of the Company or
professionals to deal with the faults,while the fridge still can keep refrigeration..
Fault content
Freezer temperature sensor failure
Freezer defrosting sensor failure.
Communication failure
Ambient temperature sensor failure
Freezer high temperature.
Fault code
E2
E5
E6
E7
E9
visible code
YES
YES
YES
YES
YES
11
Quick Freeze Funtion setting
Un-Quick freeze funtion mode :press button A to enter quick freeze mode,the temperature
icon G show 24℃”or 11℉” ,quick freeze time acquiesce in 6 hours.Press
button A again to exit.
Quick freeze funtion will not work when the cabinet as the Refrigerator
- -
Quick freeze funtion mode :press button A for 3 seconds to enter the state of quick freeze
time setting,quick freeze time icon G flickering; press button E or F to adjust the quick freeze
time, to choose 6 or 48 hours setting .To exit the setting state 10 seconds later and takes effect.
(also can press button D to lock or button A to exit and setting effect).
(If quick freeze time show 6 hours,press button F to choose 48 hours,while quick freeze
time show 48 hours,press button E to choose 6 hours.48 hours NOT be advised to choose)
LEAVING THE UNIT POWER OFF
If the unit will be power off for a long time,
the plug should be pulled out, then clean
the unit thoroughly.Ensure that the door
cannot be fully closed(leave a suitable gap),
and place the unit in a well-ventilated area
to avoid any odour.
Risk of child entrapment. Before you throw away your old refrigerator or freezer:
1, Take off the doors
2, Leave the shelves in place so that children may not easily climb inside.
Danger
12
MAINTENANCE
Please contact the after-sales Service Department of the Company or
professionals to deal with the trouble to avoid any risk.
Before calling for the service ,please check the following issues first.
POSSIBLE CAUSEPROBLEM POSSIBLE SOLUTION
1) Does not work.
No power to unit.
Power cord is unplugged.
Wrong voltage is being used.
Check connection of power
cord to power source.
Plug in unit.
Use proper voltage.
2) Refrigerator runs
continuously.
Temperature set too low.
Door is not closed.
Hot food inserted.
Door opened too long or too often.
Close proximity to heat
source or direct sunlight.
Something to plug up inlet
or outlet airflow gap
Lower temperature control.
Close door securely.
Be sure food is at room
temperature before inserting.
Minimize door openings/
duration.
Do not place unit close to
heat sources or direct
sunlight.
13
TROUBLE SHOOTING
Light
cover
Light base
Light bulb
Before changing the light bulb, please unplug the fridge first,
then pull down the light cover and change the light bulb according
to the picture as shown above.
Make sure the light bulb is AC230V/MAX.40W(E14)
Note: no extension cord used
Take down the two screws
Take Light
cover down
14
TROUBLE SHOOTING
Palsonic Customer Service
Telephone (Australia) 1300 657 888
Palsonic Corporation Pty Ltd ABN 34 000 474 108
1 Joynton Avenue, Waterloo NSW 2017 Australia
Telephone (02) 9313 7111 Facsimile (02) 9697 0655
www.palsonic.com.au
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Palsonic PW411SFZR Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI