King Canada K-X2P User manual

Brand: King Canada

Model: K-X2P

Type: User manual

INSTRUCTION MANUAL

MODEL: K-X2P

INVERTER GENERATOR

PARALLEL CABLE KIT

03/2015

IMPORTANT INFORMATION

1-YEAR

LIMITED WARRANTY

FOR THIS PARALLEL CABLE KIT

KING CANADA TOOLS

OFFERS A 1-YEAR LIMITED WARANTY

FOR NON COMMERCIAL USE.

PROOF OF PURCHASE

Please keep your dated proof of purchase for warranty and servicing purposes.

LIMITED TOOL WARRANTY

King Canada makes every effort to ensure that this product meets high quality and

durability standards. King Canada warrants to the original retail consumer a 1-year

limited warranty as of the date the product was purchased at retail and that each

product is free from defects in materials. Warranty does not apply to defects due

directly or indirectly to misuse, abuse, normal wear and tear, negligence or

accidents, repairs done by an unauthorized service center, alterations and lack of

maintenance. King Canada shall in no event be liable for death, injuries to persons

or property or for incidental, special or consequential damages arising from the use

of our products.

To take advantage of this limited warranty, return the product at your expense

together with your dated proof of purshase to an authorized King Canada service

center. Contact your retailer or visit our web site at www.kingcanada.com for an

updated listing of our authorized service centers. In cooperation with our authorized

serviced center, King Canada will either repair or replace the product if any part or

parts covered under this warranty which examination proves to be defective in

workmanship or material during the warranty period.

NOTE TO USER

This instruction manual is meant to serve as a guide only. Specifications and

references are subject to change without prior notice.

PARTS DIAGRAM & PARTS LISTS

Refer to the Parts section of the King Canada web site for the most updated parts

diagram and parts list.

KING CANADA INC. DORVAL, QUÉBEC, CANADA H9P 2Y4

www.kingcanada.com

SAFETY

FOLLOW THESE INSTRUCTIONS CAREFULLY

Proper installation of the Parallel Cable Kit is essential for safe and reliable operation.

WARNING!

This Parallel Cable Kit must ONLY be used between two identical Inverter

Generators. Never connect cables between two different inverter generators, this may

cause low voltage output, which can permanently damage the electrical devices

connected to the inverter generators.

Before use, read and understand the installation and operation instructions in this manual

to become familiar with how this Parallel Cable Kit works with two Inverter Generators with

parallel ports.

Periodically inspect the cables for damage, replace cable if its insulation is broken or

cracked.

INSTALLATION

1) Connect the two parallel connectors (A)

Fig.1 from one cable to the parallel inputs

(B) on the control panel of the first Inverter

Generator.

2) Connect the two parallel connectors from

the other cable to the parallel inputs on the

control panel of the second Inverter

Generator.

3) Attach the ground wire (C) Fig.1 to the ground terminal (D) on the control panel of the

first Inverter Generator.

4) Attach the second ground wire to the ground terminal on the control panel of the

second Inverter Generator.

SAFETY AND INSTALLATION

Figure 1

OPERATION

Warning! If high electrical loads are

connected, turn the Eco switch (A) Fig.2 to

the Off position to reduce voltage changes.

While both Inverter Generators are running,

make sure both green power indicator lights

(B) are On. If not On, turn the Inverter

Generators Off, restart both Inverter

Generators and make sure both green power

indicator lights are On.

Warning! Substantial overloading (exceeding

the rated output of 30 Amps.) will shut off the AC output. Exceeding maximum power or

slightly overloading the Inverter Generators may not switch the AC circuit protector Off, but

will shorten the service life of the Inverter Generators. Do not overload.

Warning! Only use one Parallel Cable receptacle at a time

(NEMA L5-30R or the NEMA TT-30R). When using the

Parallel Cable Kit, the 120V duplex receptacles on the

Inverter Generator control panels can not be used, only the

receptacles on the Parallel Cable box can be used.

This Parallel Cable kit comes with two receptacles;

• NEMA L5-30R Twist Lock Receptacle (A) Fig.3- Rated for

120V, max. 30 Amps. Powers electrical items having a 3

prong NEMA L5-30P Twist Lock plug.

• NEMA TT-30R RV Receptacle (B) Fig.3-Rated for 120V,

max. 30 Amps. Connect an RV power cable having a 3

prong TT-30P RV plug.

Figure 2

Figure 3

King Canada K-X2P User manual

King Canada K-X2P User manual

King Canada K-X2P User manual

Related papers

Other documents