Fire Magic Magic View Window User manual

Category
Security device components
Type
User manual

This manual is also suitable for

REV 1 - 1410010815
L-C2-398
1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
This Magic View Window is for replacement on Fire
Magic grills. Read these instructions completely prior
to installing.
1. Ensure the grill is completely cool, the knobs
are in the off position, the gas supply to your
grill is turned off, the master switch is off, and
the power supply is disconnected.
2. From the inside of the oven hood, use a fl athead
screwdriver to unfasten the nuts and washers that
are securing the window in place.
3. From the outside of the oven hood, carefully remove
the window bezel and glass.
Important: Remove any glass particles and make
sure the fl ange is completely clean prior
to proceeding.
4. Orient the new glass window onto the fl ange, making
sure it is centered in the opening. Then place the
window bezel over the glass (Fig. 1-1).
5. Loosely install the washers and nuts (Fig. 1-2). DO
NOT fully tighten.
6. Reference Fig. 1-3 for a suggested pattern to evenly
secure the window bezel (view is from inside of
hood).
Cycle the suggested tightening pattern 2-3 times
until the nuts are fully tightened. The amount of
pressure on the glass will be at a safe level once
the screwdriver can no longer tighten due to the
screws protruding through the nuts.
Important: The nuts must be tightened around the
window with even pressure. Failure to
do so will damage the glass.
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
Magic View Window
Model # 24187-45
Fig. 1-1 Orientation
Window shown installed
Fig. 1-2 Installation
Fig. 1-3 Suggested tightening pattern
15 6 11124
10
15
169
278
13
14
3
Gently secure with even pressure
  • Page 1 1

Fire Magic Magic View Window User manual

Category
Security device components
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI