Acrosser Technology AR-R6000 Owner's manual

Category
Motherboards
Type
Owner's manual
Revision: 1.1
AR-B6000 Board
Networking board for Microbox and Rackmount with 4 GbE LANs,
Atom D410/D510 +ICH8M
User Manual
1
Revision: 1.1
Copyright 2010
All Rights Reserved.
Manual’s first edition: Otc, 01, 2010
For the purpose of improving reliability, design and function, the information in
this document is subject to change without prior notice and does not represent a
commitment on the part of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use or inability to use the product or documentation, even
if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are reserved.
No part of this Manual may be reproduced by any mechanical, electronic, or other means in any
form without prior written permission of the manufacturer.
Trademarks
AR-B6000 is a registered trademarks of Acrosser; IBM PC is a registered
trademark of the International Business Machines Corporation; Atom™is a
registered trademark of Intel Technologies Inc; AMI is a registered trademark of AMI
Software International Inc; other product names mentioned herein are used for
identification purposes only and may be trademarks and/or registered trademarks of
their respective companies.
2
Revision: 1.1
3
Table of Contents
1 .........................................................................................4Introduction
1.1 Features........................................................................................................... 4
1.2 Specification................................................................................................... 5
1.3 Package Contents .......................................................................................... 6
1.4 Block Diagram ................................................................................................ 7
2 .........................................................................8Hardware Information
2.1 Location........................................................................................................... 8
2.1.1 Top Side ....................................................................................................8
2.1.2 Bottom Side ..............................................................................................9
2.2 Connector, Header and Jumper Setting Table........................................... 10
2.2.1 Pin definition for Connector..................................................................11
2.2.2 Pin definition for Header........................................................................12
2.2.3 Jumper Setting and Pin definition........................................................ 14
3 .......................................................................................15BIOS setting
3.1 Main (System Overview).............................................................................. 15
3.2 Advanced (Advanced Settings)................................................................... 15
3.3 Power (ACPI Setting).................................................................................... 16
3.4 Boot (Boot Settings)..................................................................................... 16
3.5 Exit (Exit Options) ........................................................................................ 17
4 ............................................................................................18Appendix
4.1 Appendix A - RJ45 LAN LED definition...................................................... 18
4.2 Appendix B- Front Panel LAN LED definition............................................ 19
4.3 Appendix C- Front Panel LED definition .................................................... 20
4.4 Appendix D- AR-LCM definition.................................................................. 22
Revision: 1.0
1 Introduction
Welcome to the AR-B6000 series Computer. The AR-B6000 series is an Networking
board for Microbox and Rackmount with 4 sets of GbE LAN.Intel Atom (Pineview-D)
D410/D510 +ICH8M
AR-B6000D41, Networking board for microbox and Rackmount Platform with Intel
Atom D410 +ICH8M, 4*10/100/1000 LAN
AR-B6000D51, Networking board for microbox and Rackmount Platform with Intel
Atom D510 +ICH8M, 4*10/100/1000 LAN with by-pass
1.1 Features
Processor:
AR-B6000D41 Intel® Atom™Processor D410 (Single Core, 512K L2 Cache,
1.66 GHz)
AR-B6000D51 Intel® Atom™Processor D510 (Dual Core, 2X 512K L2 Cache,
1.66 GHz)
Chipsets: Intel® ICH8M
Memory: DDR2 667/800MHz SO-DIMM, Maximum 2GB
Display: VGA
Storage: 1x CF, 2x SATA II,
Communication: 4x Gbps Ethernet, 7x USB 2.0, 3x RS-232, 1x RS-232/422/485
General: Watchdog timer, 8-bit GPIO, and PCI-104 expansion slot.
4
Revision: 1.0
1.2 Specification
System
CPU AR-B6000D41 Intel® Atom™Processor D410 (512K L2 Cache, 1.66 GHz)
AR-B6000D51 Intel® Atom™Processor D510 (2X 512K L2 Cache, 1.66 GHz)
Memory One SO-DIMM socket support 667/800 MHz DDR2 SDRAM up to 2GB
Graphic
Controller
Intel® GMA 3150
Gen3.5+ GFX Core, GFX Render Core Frequency @ 200MHz (400MHz), DX9
Video Memory DVMT 4.0, Maximum 256MB shared
Intel® Dynamic Video Memory Technology support 4.0
Video Interface 1 x VGA port (DB15)
Chipset Intel® ICH8M
Thermal
solution
FAN connector for CPU FAN
Fan connector for system FAN*2
BIOS 1. support console redirection(default enable)
2. support bypass setting(default disable)
3. support boot from LAN
Super I/O W83627DHC
Network Interface
Ethernet 4 *RJ45 JACK with LED (Refer to Appendix A)
Intel 82574L (10/100/1000Mbps) (L1~L4),
LAN by-Pass LAN1 and LAN2 support by-pass function
Reserve 1*3 pin Jumper for Hardware select bypass status.
AR-B6000D51 and AR-B6000D51H only
I/O
Front panel From left to right:
1. LAN1/ LAN2/ LAN3/ LAN4 LED: 1000, 10/100, Act. (Refer to Appendix B)
2. Power LED/HDD/Bypass: Green/Green/Yellow (Refer to Appendix C)
Rear panel From left to right:
Power Inlet
2 * USB (use standby power)
COM port (DB9)
LAN4/ LAN3/ LAN2
Reset Button
LAN1
Internal I/O
1. 4 xUSB 2.0(2.54 pitch)
Mini-PCI
PCI slot
GPIO:
Use super I/O game port as GPIO
2x5 pin 2.0mm Pin Head
8-bit GPIO, 1 x GND, 1 x 3.3V/5V jumper selectable
LCM pin head( 7-pin pinhead 2.54mm)
Power input (Mini Fit 4 pin Co-lay with power inlet)
1*8 pin 2.54mm reserve for CPLD update
VGA pin head(2*5pin, 2.0mm
Panel connector(2*4pin, 2.54mm)
5
Revision: 1.0
6
Storage
CF 1 x Compact Flash socket, Type-II Socket
(Master mode) Support UDMA
SATA 2 x SATAII interface with power(JST 4 pin)
Others
Watchdog
Timer
Software programmable 1~255 Seconds,
Battery Lithium Battery, 3V 220mAH (CR2032)
Hardware
monitoring
CPU voltage
CPU and System Temperature
OS support Win XP/XP Embedded, Fedora 10(2.6.27)
Mechanical
Dimension 218 x 146mm
Operating
Temperature
0~60oC (32~140oF)
Storage
Temperature
-20~80oC (-4~176oF)
Relative
Humidity
0 to 90% @ 40°C, non-condensing (95% @ 40°C, Non-Condensing by request)
Power Supply N/A
Power
Requirements
12V Single Voltage Input
ATX circuit as AT mode
EMC & Safety
EMC CE, FCC Class B
Safety N/A
1.3 Package Contents
Model Name Part Lists QTY Remark
AR-B6000 series 1
AR-B6000
series
Revision: 1.0
1.4 Block Diagram
7
Revision: 1.0
2 Hardware Information
This chapter describes the installation of AR-B6000. At first, it shows the Function
diagram and the layout of AR-B6000. It then describes the unpacking information
that you should read carefully, as well as the jumper/switch settings for the
AR-B6000 configuration.
2.1 Location
2.1.1 Top Side
8
Revision: 1.0
2.1.2 Bottom Side
9
Revision: 1.0
2.2 Connector, Header and Jumper Setting Table
10
Revision: 1.0
2.2.1 Pin definition for Connector
Item Connector NAME DESCRIPTION
C1
DC_JACK1
Power Inlet
C2
ATX12V_1
Power input (CO lay with Power inlet)
C3
FAN1 , FAN2, FAN3
FAN connector*3 ( for CPU FAN*1, System FAN*2)
C4
COM2
C5
SATA_PWR1,SATA_PWR2
11
Revision: 1.0
2.2.2 Pin definition for Header
Item HEADER NAME DESCRIPTION
H1
F_PANEL
H2
LCM1
H3
VGA1
H4
GPIO1
H5
USB34,USB56
H6
CPLD_FH
12
Revision: 1.0
13
H7
HiFN_FH
Revision: 1.0
2.2.3 Jumper Setting and Pin definition
Item JUMPER NAME DEFAULT DESCRIPTION
J1
CLRTC 1-2 CLR CMOS
NORMAL (Default)
2-3 CLR CMOS
J2
GPIOVS
1-2 GPIO Voltage selection
1-2 +V5 (Default)
2-3 +V3.3
J3
BP_SEL
2-3 Bypass selection
1-2 Bypass
2-3 NORMAL (Default)
J4
PSON
2-3 ATX / AT Mode
2-3 AT Mode (Default)
2.2.4 DIP Switch Setting
Item SWITCH NAME DEFAULT DESCRIPTION
SW2
All ON CPLD setting
14
Revision: 1.0
3 BIOS setting
3.1 Main (System Overview)
3.2 Advanced (Advanced Settings)
15
Revision: 1.0
3.3 Power (ACPI Setting)
3.4 Boot (Boot Settings)
16
Revision: 1.0
17
3.5 Exit (Exit Options)
Revision: 1.0
4 Appendix
4.1 Appendix A - RJ45 LAN LED definition
LED
Position
LED
Function
LED Color On Off Blinking
Left(LED2) Link/Activity Yellow Link No Link Link with
Activity
Orange 1000 MbpsRight(LED1) Data Speed
Green 100 Mbps
10 Mbps Not
Applicable
18
Revision: 1.0
4.2 Appendix B- Front Panel LAN LED definition
LED Position LED Function LED Color On Off
Upper 1000 Data
speed
Green Link with
1000Mbps
transfering
No Link
Middle 10/100Data
Speed
Green Link with
100Mbps
transfering
10 Mbps
Down Active Yellow LAN Active LAN not
active
19
Revision: 1.0
4.3 Appendix C- Front Panel LED definition
LED Position
LED Function LED Color On
Upper Power LED Green System powered on.
Middle HDD Green HDD is activating.
Down Bypass Yellow Bypass function enabled.
20
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22

Acrosser Technology AR-R6000 Owner's manual

Category
Motherboards
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI