Brodit 654853 Datasheet

Product 654853

654853 ProClip

Center mount

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320286548533

Item no 654853 fits:

Toyota RAV 4 11-12 (For all countries)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the ProClip. It is important to place the

ProClip exactly as shown in the pictures.

1. Press the thin end of the enlcosed gap opener into the gap between the frame surrounding the air vent and the

panel surrounding the display, to widen the gap. Use the enclosed alcohol pad to clean the area where the

ProClip is to be installed. Peel off the adhesive tape covers on the ProClip. Press the curved edge on the lower

part of the ProClip into the gap next to the gap opener.

2. Press forward on the lower part of the ProClip, in the same time press downward on top of the ProClip so the

ProClip flexes slightly.

3. Press the upper part of the ProClip forward so the thin edge goes into the upper part of the air vent. When the

edge on the upper part is positioned by the frame surrounding the air vent: release the preassure so the ProClip

flexes back and the adhesive tape attaches to the upper edge of the air vent. Pull out the gap opener.

4. The ProClip is in place.

2(2)

Download PDF