Elkay EDF210C User manual

Elkay
Brand
Elkay
Model
EDF210C
Category
Vacuum cleaners
Type
User manual

This manual is also suitable for

Elkay EDF210C is a drinking fountain with two stations. It features a bubbler assembly, pedestal, regulator, strainer, and wasteline. The bubbler assembly includes a button that activates the water flow. The pedestal supports the bubbler assembly and provides a stable base for the fountain. The regulator controls the water flow rate and ensures that the water is dispensed at a consistent temperature. The strainer removes impurities from the water, and the wasteline drains the water away from the fountain.

Elkay EDF210C is a drinking fountain with two stations. It features a bubbler assembly, pedestal, regulator, strainer, and wasteline. The bubbler assembly includes a button that activates the water flow. The pedestal supports the bubbler assembly and provides a stable base for the fountain. The regulator controls the water flow rate and ensures that the water is dispensed at a consistent temperature. The strainer removes impurities from the water, and the wasteline drains the water away from the fountain.

98129C (3/05)
EDF210C / EDF310C FOUNTAIN
PAGE 1
IMPORTANT
INSTALLATION INSTRUCTIONS
1. Familiarize yourself with the components of the drinking fountain.
2. Determine location of rough-in and plumbing connections. Mount hanger bracket(s) to wall at desired height.
3. Install fountain to wall. Install additional fasteners to bolt fountain securely to wall.
4. Connect strainer to water supply (service stop). Refer to figure 5. DO NOT SOLDER TUBES INSERTED INTO THE STRAINER AS
DAMAGE TO THE O-RINGS MAY RESULT. Connect trap to waste stub and fountain.
5. Turn on water supply and check for leaks at all plumbing and drain connections. Fix all leaks as required.
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A
COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN ELECTROLYSIS WHICH
CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS
AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER
SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.
EDF210C & EDF310C Series Fountains
INSTALLATION, CARE & USE MANUAL
EDF210C TWO STATION FOUNTAIN
EDF310C THREE STATION FOUNTAIN
98129C (3/05)
EDF210C / EDF310C FOUNTAIN
PAGE 2
ROUGH - IN DIMENSIONS
EDF210C (TWO STATION)
FIG. 1
ROUGH - IN DIMENSIONS
EDF310C (THREE STATION)
FIG. 2
98129C (3/05)
EDF210C / EDF310C FOUNTAIN
PAGE 3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
ITEM NO. PART NO. DESCRIPTION
56073C
40169C
40048C
40089C
40322C
56011C
55997C
61313C
75580C
45336C
50074C
28568C
55996C
56092C
70682C
45852C
45853C
45854C
15005C
28580C
50986C
45855C
Bubbler Assy.
Hex Nut
Button
Cover
Orifice Assy.
Bubbler Housing
Pedestal
Regulator
Locking Nut
Strainer/Ferrule Assy.
Gasket - Tailpipe
Fountain
Strainer
Polytubing
Tee - 1/4
Trap Assy.
Wasteline Tee Assy.
Tailpipe
Regulator Retaining Nut
Hanger Bracket
Regulator Holder
Wasteline
ITEMIZED PARTS LIST
FIG. 5
FIG. 6
NOTE: WATER FLOW
DIRECTION
BUILDING WATER INLET
SERVICE STOP
(NOT FURNISHED)
1/4" O.D. TUBE
WATER INLET
TO COOLER
3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY
1 - SEE FIG. 3
FIG. 3
FIG. 4
1
5
6
7
9
13
14
14
14
14
15
12
20
2, 3, 4,
8, 19, 21
10, 11
17
16
22
18
10, 11
98129C (3/05)
EDF210C / EDF310C FOUNTAIN
PAGE 4
PRINTED IN U.S.A.
TROUBLE SHOOTING AND MAINTENANCE
Orifice Assy: Mineral deposits on orifice can cause water
flow to spurt or not regulate. Mineral deposits may
be removed from the orifice with a small round file or small
diameter wire. CAUTION: DO NOT FILE OR CUT ORIFICE
MATERIAL.
Actuation of Quick Connect Water Fittings: Cooler is
provided with lead-free connectors which utilize an o-ring
water seal. To remove tubing from the fitting, relieve water
pressure, push in on the gray collar while pulling on the tubing
(see figure 6).
Bubbler Replacement: When installing replacement
bubbler and pedestal, tighten nut (Item 9, figure 3) only to hold
parts snug in position. Do not overtighten.
1 - SEE FIG. 3
FIG. 7
2, 3, 4,
8, 19, 21
ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484
2, 3, 4, 8
16
17
18
18
23
22
24
10, 11
10, 11
10, 11
14
14
14
14
14
14
14
13
17
15
20
20
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
ITEM NO. PART NO. DESCRIPTION
56073C
40169C
40048C
40089C
40322C
56011C
55997C
61313C
75580C
45336C
50074C
28569C
55996C
56092C
70682C
45852C
45853C
45854C
15005C
28580C
50986C
45857C
45858C
45856C
Bubbler Assy.
Hex Nut
Button
Cover
Orifice Assy.
Bubbler Housing
Pedestal
Regulator
Locking Nut
Strainer/Ferrule Assy.
Gasket - Tailpipe
Fountain
Strainer
Polytubing
Tee - 1/4
Trap Assy.
Wasteline Tee Assy. (Vertical)
Tailpipe
Regulator Retaining Nut
Hanger Bracket
Regulator Holder
Wasteline (J-Tube)
Wasteline (Straight)
Wasteline Tee Assy. (Horizontal)
ITEMIZED PARTS LIST
12
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Elkay EDF210C User manual

Elkay
Brand
Elkay
Model
EDF210C
Category
Vacuum cleaners
Type
User manual
This manual is also suitable for

Elkay EDF210C is a drinking fountain with two stations. It features a bubbler assembly, pedestal, regulator, strainer, and wasteline. The bubbler assembly includes a button that activates the water flow. The pedestal supports the bubbler assembly and provides a stable base for the fountain. The regulator controls the water flow rate and ensures that the water is dispensed at a consistent temperature. The strainer removes impurities from the water, and the wasteline drains the water away from the fountain.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents