2. Home
  3. Do-It-Yourself tools
  4. Garden tools
  5. Agri-Fab
  6. 45-03052

Agri-Fab 45-03052 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Agri-Fab 45-03052 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
OWNERS
MANUAL
Model No.
45-03052
63" FINISH CUT
TRAILMOWER
PRINTED IN U.S.A. FORM NO. 40104 (8/21/07)
CAUTION:
Read Rules for
Safe Operation
and Instructions
Carefully
• Assembly
• Operation
• Maintenance
• Parts
the fastest way to purchase parts
www.speedepart.com
™
IMPORTANT:BATTERYREQUIRED!!ThebatteryisNOTincluded
withthedeckbutmustbepurchasedseparately.A12voltlawntractor
batterywith260/300coldcrankingampsanddimensionsof6-1/8"Hx
7-5/8"Lx5-1/8"Wisrecommendedtooperatethemachine.
2
SAFETY RULES .............................................3-4
SAFETY AND OPERATION DECALS ............5-6
PARTS BAG CONTENTS ..................................7
ASSEMBLY ...................................................8-11
OPERATION ...............................................12-17
CUSTOMER RESPONSIBILITIES ..............18-21
STORAGE ........................................................22
WIRING DIAGRAM ..........................................23
REPAIR PARTS ...........................................24-30
PARTS ORDERING ........................BACK PAGE
TABLE OF CONTENTS
3
4
5
SAFETY AND OPERATIONAL DECALS
Replacedecalimmediatelyifdamaged.Orderbypartnumber.Seebackcover.
6
SAFETY AND OPERATIONAL DECALS
Replacedecalimmediatelyifdamaged.Orderbypartnumber.Seebackcover.
7
KEY QTY. DESCRIPTION
 H 2 "S"Hook
 I 6 CableClip
J 1 Key
 K 1 SwitchCover
 L 1 SwitchNut
M 1 Switch
 N 1 ThrottleControlKnob
KEY QTY. DESCRIPTION
 A 2 Bolt,Hex1/4"x3/4"
 B 2 Screw,PanHead#10-24x1/2"
 C 3 Screw,SelfTapping#10-16x1/2"
 D 2 Nut,HexwithWasher,1/4"
 E 2 Nut,Hex#10-24
 F 2 LockWasher,#10
 G 1 BatteryHoldDownStrap
CONTENTS OF PARTS BAG
SHOWN FULL SIZE
NOT SHOWN FULL SIZE
A C B
D E F
G
H I J
K L M N
8
ASSEMBLY
9
ASSEMBLY
10
ASSEMBLY
11
NOTES
12
OPERATION
13
OPERATION
14
OPERATION
15
OPERATION
MOWER HEIGHT ADJUSTMENT
Thecuttingheightrangeisapproximately1-1/2to4-1/2
inches.Theheightsaremeasuredfromthegroundto
thebladetipwiththeengineshutoff.Theaveragelawn
shouldbecuttoapproximately2-1/2inchesduringthe
coolseasonandtoover3inchesduringhotmonths.The
particularheightmayvarydependingonsoilconditions,
typeofgrassandheightofgrassbeingmowed.For
healthierandbetterlookinglawns,mowoftenandafter
moderategrowth.Forbestcuttingperformance,grass
over6inchesinheightshouldbemowedtwice.Makethe
rstcutrelativelyhigh,thesecondtothedesiredheight.
TO ADJUST MOWER CUTTING HEIGHT
• Removehaircotterpinfromlocatingpin.(SeeFig.6)
• Applyliftpressuretoheightadjustmentliftlever.
• Remove the locating pin from the height adjustment
strap.
• MoveheightadjustmentLiftLeverupordowntoalign
itwiththedesiredholeintheheightadjustmentstrap.
• Reassemblelocatingpinintotheheightadjustmentstrap
and secure with hair cotter pin.
• Makesurethatbothsideheightadjustmentstrapsare
adjustedtothesameheight.
FRONT TO BACK RAKE ADJUSTMENT
Toobtainthebestcuttingresultsandtoreduceengine
load,themowerhousingshouldbeadjustedsothatthe
frontisapproximately1/2"to1"lowerthantherear.To
checkfronttobackadjustment,measurefromthebottom
edgeofthedecktothegroundatbothfrontandrearof
the deck.
TO ADJUST MOWER FROM FRONT TO BACK
• Removetwohaircotterpinsfromtwoclevispinsinthe
towbaradjustment.(SeeFig.6)
• Removetwoclevispinsfromtowbaradjustment.
• Raiseorlowerthetowbartoobtaintheproperfrontto
backadjustment.
• Reassembletwoclevispinstotowbaradjustmentand
secure with two hair cotter pins.
FRONT GAUGE WHEEL ADJUSTMENT
Theheightofthefrontgaugewheelsisadjustableto
helppreventthefrontcornersofthemowerfromgouging
intothesoilwhenmowingonuneventerrain.Thefactory
settingofthewheels(highestofthreepositions)is
adequateformostlawnconditions.Ifthewheelsare
lowered,theymustclearthegroundwhenthemoweris
setatthedesiredcuttingheightwithfronttobackrake.
TO ADJUST FRONT GAUGE WHEELS
• Removelocknutandwasherfrombolt.
• Movegaugewheelwithbolttodesiredheightsetting.
• Reassemblelocknutandwasherontobolt.
• Adjustjamnutifwheelistootightorhasendplay.
CAUTION:SHUTOFFMOWERENGINE
ANDREMOVESPARKPLUGWIREFROM
SPARKPLUGBEFOREMAKINGANY
ADJUSTMENTSTOTHEMOWER.
16
OPERATION
17
OPERATION
IMPORTANT: Avoidprolongedmowingofditcheswith
slopesgreaterthan15degrees.Smallenginesbecome
starvedforoilatanglesgreaterthan15degreesand
shouldonlybeusedforbriefperiodsonsuchslopes.Be
suretheengineislledtothemaximumoillevelwhen
mowingonslopes.
18
CUSTOMER RESPONSIBILITIES
19
CUSTOMER RESPONSIBILITIES
20
CUSTOMER RESPONSIBILITIES
FIG. 11
/