2. Balboa
  3. 1" Air Control

Balboa 1" Air Control Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Balboa 1" Air Control Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1” AIR CONTROL INSTRUCTIONS
The correct hole size for the 1” air control is 1-3/4”
Before drilling hole to install the air control, make sure mounting surface is flat. This will help assure 1.
the best seal.
Drill one 1-3/4” hole for the air control.2.
Remove nut (#4) and gasket (#3) from air control. 3.
Place silicone on backside of flange of air control body (#2) and install air control through hole in 4.
spa/bathtub.
Place gasket (#3) onto body (#2) on the outside of spa/bathtub. 5.
Hand tighten nut (#4) onto body (#2). 6.
Remove excess silicone from around flange of air control and surface of spa/bathtub. 7.
Glue 1” pipe to bottom of air control. 8.
DO NOT USE ANY TYPE OF PETROLEUM BASED LUBRICANTS ... THEY WILL DAMAGE THE
PRODUCT.
#1 1” AIR STEM ASSEMBLY 30-2108
#2 1” AIR BODY ASSEMBLY 30-2107
#3 1” GASKET 30-3705
#4 1” NUT 30-3706
88-2100 Rev C July 1, 2009
/