2. Orion
  3. Hypnoray ORFX5

Orion Hypnoray ORFX5 User manual

  • Hello! I am an AI chatbot trained to assist you with the Orion Hypnoray ORFX5 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
User Manual
ORION Hypnoray [ORFX5]
Introduction
With 64 power efficient red, blue and green LEDs, the ORFX5 is a cost effective, easy to operate lighting effect
suitable for a wide variety of recreational and home uses.
Warnings
For indoor use only
Caustic chemicals or liquids can cause damage to the housing.
Operating temperature: < 40°C.
Do not disassemble the fixture yourself. Please consult a qualified technician for service and repair.
Specifications
Power supply: AC120V 60Hz
Power：20 W
Light source: 64 red, green, blue, white LEDs.
Operating modes: AUTO, AUDIO, TEST
Dimensions: 434 x 289 x 205mm
Weight: 3.8 KG
Back Panel
1-Sensitivity 2-Power 3-MENU 4-UP 5-DOWN 6-ENTER 7-Mic
Power-on reset
The system will be reset when powered on, and return to the operating mode it was in prior to shutdown. If
no buttons are pushed for 10 seconds, it will return to main MENU. After 20 seconds the display will dim.
Modes of Operation
Press MENU to toggle between operating modes (Auto, Audio, or Test). When the desired mode appears
in the display, press ENTER to select.
Auto Mode
Press the MENU button until [A.U.T.O.] appears in the display. Press ENTER to select. Once in AUTO
mode, press the MENU button to toggle between mode parameters:
1. Program: program #01-09
2. Speed: program speed #01-10 (slowest to fastest)
3. Strobe: strobe time #00-10 (slowest to fastest, 0=no strobe)
Press UP or DOWN to toggle between mode parameter values.
Press ENTER to select value.
Audio Mode
Press the MENU button until [S.O.N.D.] appears in the display. Press ENTER to select. Once in AUDIO
mode, press the MENU button to toggle between mode parameters:
1. Program: select program #01-09
2. Strobe: select strobe time #00-10 (slowest to fastest, 0=no strobe)
Press UP or DOWN to toggle between mode parameter values.
Press ENTER to select value.
Test Mode
Press the MENU button until [T.E.S.T.] appears in the display. Press ENTER to select. Once in TEST mode,
press the MENU button to toggle between mode parameters.
Press UP or DOWN to toggle between mode parameter values.
Press ENTER to select value.
P.
g
. X.X. S.
p
.X.X. S.b.X.X.
P.g.X.X. S.b.X.X.
T.E.S.T. B. L.U.E. W.I.T.E. G. R.E.E.
A.U.T.O.
S.O.N.D.
.R.E.D.
/