Giagni MM101-ORB Installation guide

Brand
Giagni
Model
MM101-ORB
Type
Installation guide

This manual is also suitable for

1
3
25
4
Wall Mounted Mirror
Installation Instructions
Contents (quantity):
1
Mirror Assembly (1)
Mounting Plate (1)
Masonry Anchors (2)
Screws (2)
Cap Nuts (2)
2
3
4
5
MM101
Series
1. Remove the mounting plate from the mirror assembly
by unscrewing the cap nuts. Do not remove the pre-assem-
bled screws on the mounting plate.
2. Choose the mounting position. Height is the most critical
since the mirror does not adjust up and down, just tilts. Allow
for a comfortable position while standing with the mirror
nearly at full extension. Mounting the mirror onto a wall
stud is HIGHLY recommended.
3. Place the mounting plate on the wall in the preferred
position and mark the location of the two holes. Be sure the
holes are plumb (vertically level).
4. For drywall: Drill two 1/8” holes to confirm stud location. If
using studs, secure mounting plate to stud with two
screws. If not using studs, heavy-duty wall anchors are
recommended (not included).
5. For masonry walls, drill 5/16” holes and use masonry
anchors and screws (included).
6. Place mirror assembly onto the threaded studs on the
mounting plate, and secure with the cap nuts.
548 So. Columbus Avenue Mount Vernon, NY 10550
Customer Service: 1-888-560-5222
email us at [email protected]
A QMI, Inc. Brand
  • Page 1 1

Giagni MM101-ORB Installation guide

Brand
Giagni
Model
MM101-ORB
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents