2. Quinn
  3. 52 Inch and 100 Inch
52 Inch and 100 Inch

Quinn 52 Inch and 100 Inch User manual

  • Hello! I am an AI chatbot trained to assist you with the Quinn 52 Inch and 100 Inch User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page 1For technical questions, please call 1-888-866-5797.Item 58363
SAVE THESE INSTRUCTIONS
UPC 193175506849 23b
IMPORTANT SAFETY INFORMATION
Read all safety warnings and all instructions. Save all warnings and
instructions for future reference.
1. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
2. Secure tightly in place against solid points
before use. Do not overtighten.
3. Use as intended only.
4. Inspect before every use; do
not use if damaged.
5. Keep away from children.
Assembly / Operation
1. On the Main Cutting Guide rotate the Movable Stop handle 90 degrees to unlock Stop.
Rotate 90 degrees
to unlock
Movable Stop
Fixed Stop
Main
Cutting Guide
2. Position the Fixed Stop and Movable Stop on opposite sides of workpiece. Adjust Movable Stop
until both Stops are pressed tightly against workpiece. Rotate the Movable Stop handle 90 degrees
to lock Movable Stop and secure Guide in place.
Movable Stop handle Movable Stop handle
in locked position.in locked position.
Fixed Stop
Movable Stop
52" & 100" CLAMP AND CUTTING EDGE GUIDE
ASSEMBLY and OPERATION INSTRUCTIONS
Page 2 For technical questions, please call 1-888-866-5797. Item 58363
SAVE THESE INSTRUCTIONS
UPC 193175506849 23b
3. To attach Cutting Guide Extension for additional length, first remove
four M4 x 5 Screws from the stems on the Extension.
M4 x 5
Screw
Cutting Guide
Extension
Remove four
M4 x 5 Screws
4. Insert stems on Cutting Guide Extension into grooves of Main Cutting Guide and press together
firmly. Connect the two segments together with the M4 x 5 Screws. Tighten securely.
Cutting Guide
Extension
Main
Cutting Guide
Main
Cutting
Guide
Cutting
Guide
Extension
Install
four
M4 x 5
Screws
5. To disassemble for storage after use, remove the four M4 x 5 Screws. Press the Release
Button in the middle where the two segments meet and separate the Main Cutting Guide from
the Cutting Guide Extension. Replace the M4 x 5 Screws on the Cutting Guide Extension.
Press
Release
Button Replace
four
M4 x 5
Screws
Remove
four
M4 x 5
Screws
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
/