Remote Control

Pivo Remote Control User manual

  • Hello! I've reviewed the user manual for the Pivo Remote Control and Pivo Pod. The document provides instructions on how to pair these devices. I'm ready to answer any questions you have about this process.
  • How do I enter Remote Control pairing mode?
    How do I connect the Remote Control?
    What is the working range of the Remote Control?
Pairing Remote Control
Follow these simple steps to pair your Pivo device with its Remote Control.
1. With your Pivo Pod turned on, enter Remote Control pairing mode by
pressing the Pivo Pod's power button 3 times in quick succession. The power
button will blink white, indicating your Pivo Pod is now discoverable by the
Remote Control. If the LED light isn't blinking white, simply repeat this step.
2. On the Remote Control, press and hold the center button marked + until the
device beeps 3 times indicating a successful connection.
3. The Remote Control is now connected and ready to use.
Remote Control
Range
Pivo's Remote Control has a working range of up to 50 ft/15 m. For optimal performance,
it's best to make sure there is a clear, unobstructed path between your Pivo Pod and the
Remote Control.
Battery type
The Remote Control uses replaceable 3V coin-type batteries (CR1632). Two batteries are
included in the Remote Control. Carefully remove the batteries' protective plastic
strips before pairing to the Pivo Pod.
Note: The Remote Control command may vary depending on the modes and features used.
1/3