2. CUES
  3. LAMP II
LAMP II

CUES LAMP II Installation guide

  • Hello! I have read the document describing the Lamp II Troubleshooting class, which includes training on maintenance, assembly, and troubleshooting with the K2 system. I understand the class is a one-day event, covering topics like the Lamp II launcher, push block assembly, and LED light head build. I'm ready to answer your questions about the class or the Lamp II system!
  • What is a prerequisite for this class?
    What is the duration of the class?
    What is the cost of the class?
Corporate Office:
3600 Rio Vista Avenue, Orlando, FL 32805 • Telephone (407) 849-0190 / (800) 327-7791 • Fax (407) 425.1569
LAMP II TROUBLESHOOTING
This is a one day class.
Prerequisite: TV Operator Troubleshooting Class.
This is an instructional class using power points and hands on training.
Topics covered in this session:
Basic maintenance and care of Lamp II launcher.
Lamp II push block assembly.
Brown cable end terminations.
Adding Lamp II into K2 system.
Lamp II LED light head build and troubleshooting.
Troubleshooting Lamp II on TV trucks.
This session is based on how Lamp II works with the K2 system.
** Note: All students are responsible for their own accommodations and meals.**
Class is from 8am until 3pm with one hour for lunch (approximately 6 hours class time).
Cost of this class is $300 / per person.
/