Revo RWRA014 Installation guide

Type
Installation guide
1
1. Remove the 4 x phillips head screws (and set them aside) that hold the control box
cover to the control box backing plate.
3. Remove the screws that hold the
control plug wires to the contactor
and detach these current control
plug wires.
Make note of what colour wire
goes to what location.
Revo Winch Control Plug Relocation Kit
Installation Guide
2. Lift the cover to reveal the coloured control plug wires.
Yellow Wire
2
(Step 3 Continued...)
Black Wire Brown Wire
4. Undo the 13mm bolt and nut slightly to release the red wire.
5. Undo the backing nut on the control plug and discard plug assembly.
Red Wire
3
6. Install the new extended control box plug by feeding the wires through the hole in the
control box cover where the original control plug was removed.
7. Now reverse the process. Connect the corresponding coloured wires from the
extended control plug to the contactor. Re-applying the screws.
Red Wire (Make sure to tighten the 13mm nut.)
Brown Wire
4
Yellow Wire
Black Wire
8. Replace the control box cover and t the 4 original screws.
9. Mount the angle bracket and new
plug in a convenient location.
(E.g. In the vehicles grille or
under the bonnet etc.)
10. Test operation by plugging in the
wired hand controller, as per the
winch instructions.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Revo RWRA014 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI