2. Revo
  3. RWRA014
RWRA014

Revo RWRA014 Installation guide

  • I have reviewed the provided installation guide for the REVO Winch Control Plug Relocation Kit. This document details how to relocate the winch control plug using the included parts and how to mount the plug in a preferred location. I'm ready to answer any questions you may have regarding the installation process or the device itself.
  • What needs to be removed to access the control plug wires?
    What is the first step after revealing the control plug wires?
    What should be done with old control plug?
1
1. Remove the 4 x phillips head screws (and set them aside) that hold the control box
cover to the control box backing plate.
3. Remove the screws that hold the
control plug wires to the contactor
and detach these current control
plug wires.
Make note of what colour wire
goes to what location.
Revo Winch Control Plug Relocation Kit
Installation Guide
2. Lift the cover to reveal the coloured control plug wires.
Yellow Wire
2
(Step 3 Continued...)
Black Wire Brown Wire
4. Undo the 13mm bolt and nut slightly to release the red wire.
5. Undo the backing nut on the control plug and discard plug assembly.
Red Wire
3
6. Install the new extended control box plug by feeding the wires through the hole in the
control box cover where the original control plug was removed.
7. Now reverse the process. Connect the corresponding coloured wires from the
extended control plug to the contactor. Re-applying the screws.
Red Wire (Make sure to tighten the 13mm nut.)
Brown Wire
4
Yellow Wire
Black Wire
8. Replace the control box cover and t the 4 original screws.
9. Mount the angle bracket and new
plug in a convenient location.
(E.g. In the vehicles grille or
under the bonnet etc.)
10. Test operation by plugging in the
wired hand controller, as per the
winch instructions.
/