Traxxas 9495 Operating instructions

Type
Operating instructions
Adjusting Gear Mesh
Incorrect gear mesh is the most
common cause of stripped spur
gears. Gear mesh should be
checked and adjusted anytime
a gear is replaced. To set the
gear mesh, cut a narrow strip
of notebook paper and run it
into the gear mesh. Loosen
the motor screws and slide the
motor and pinion gear into the
spur gear. Retighten the motor
screws and then remove the
strip of paper. You should be
able to run a fresh strip of paper
through the gears without binding them.
3640
46mm
3640
46mm
2578
3x12 BCS
3159
3x10 CS
2577
3x10 BCS
2577
3x14 BCS
4628R
M3/12.5
4628R
M3/12.5
2554
3x6 CS
4690 90T
4686 86T
4683 83T
4676 76T
2542
4x12 CCS
2542
4x12 CCS
2552
3x12 CCS
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
KC2940-R01 211110
Pro Series Magnum 272R Complete Transmission Instructions
Covers Part #9495
Model 58034-1 Slash shown. Other models are similar.
Please refer to the exploded views included with your
model for detailed assembly.
Tools required:
1.5 mm hex wrench
2.0 mm hex wrench
2.5 mm hex wrench
7 mm nut driver
Motor Screws
Strip of
paper
90-tooth spur gear installed.
24054 Bandit 4683 83T 37054 Rustler 4690 90T
24076 Bandit VXL 4676 76T 37076 Rustler VXL 4683 83T
36054 Stampede 4690 90T 58034 Slash 4690 90T
36076 Stampede VXL 4686 86T 58076 Slash VXL 4686 86T
Visitez Traxxas.com/manuals pour télécharger
les instructions dans votre langue.
Visite la página Traxxas.com/manuals para
descargar el instrucciones en su idioma.
Auf Traxxas.com/manuals, können Sie
anleitung in Ihrer Sprache downloaden.
3642X
12.0 SS
2579
3x15 BCS
2579
3x15 BCS
3642X
12.0 SS
3642X
12.0 SS
3642X
12.0 SS
58034 and 58076 Slash Models only:
Included bumper brace required
for proper fitment with the new
transmission.
5552
5552
5552X
5556 5556
2554
3x6 CS
2554
3x6 CS
2593
3x14 BCS
4676 - 76T
3792
1747
4.0 NL
5116
5x11x4 BB
3229
2.5x10 CS
3229
2.5x10 CS
2578
3x12 BCS
2580
3x20 BCS
2591
3x23 BCS
2580
3x20 BCS 2578
3x12 BCS
2578
3x12 BCS
2422
5646
3x3 GS
5116
5x11x4 BB
5116
5x11x4BB
5116
5x11x4 BB
5116
5x11x4 BB
5119
10x15x4 BB
5119
10x15x4 BB
2578
3x15 BCS
2578
3x15 BCS
2578
3x15 BCS
2578
3x15 BCS
2429
2578
3x12 BCS
3159
3x10 CS
3159
3x10 CS
3351R
9493
9490X opt.
9490A opt.
9490G opt.
9490P opt.
9490R opt.
9493
9493
9491 opt.
9450
2578
3x12 BCS
9460
9460X opt.
9464 opt.
9490
9489
9494
9494
2754
9492
9480
9492
9450
9450
9450
9450
9450
9450
9450
Pro Series Magnum 272R Transmission Assembly
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
Tuning the Sealed Differential
The differential is sealed to maintain consistent long-term performance. Changing the oil in the differential with either lower or higher viscosity oil will
vary the performance characteristics of the differential. From the factory, the differential is filled with black lithium grease, but can also be tuned with
silicone differential oil. Only use silicone oil in the differential. The differential has to be removed from the transmission and disassembled to change/
replace the oil.
Follow the steps below to access and refill the sealed differential:
1. Remove the four 2.5x10mm cap screws from the bottom of the transmission to remove the differential cover.
2. Slide the differential out of the transmission case.
3. Remove the 2.5x10mm button-head cap screws from the differential and carefully pull the differential halves apart.
Work over a towel to collect any fluid that drips from the differential.
4. Drain the fluid from the
differential. You may wish to
remove the spider gears from the
differential to make this easier.
5. Place the spider gears back into
the differential carrier (if you
removed them). Fill the carrier
with fluid until the cross pins
are covered.
6. Rejoin the differential halves,
using care to align the screw
holes. Be sure the rubber gasket
is in place or the differential
may leak.
7. Install the 2.5x10mm button-head
cap screws and tighten securely.
8. To reinstall the differential, reverse
the steps.
3229
2.5x10 CS
3229
2.5x10 CS
Sealed Differential Removal
5119
10x15x4 BB
5119
10x15x4 BB
9481
9481
9481
9482
9481
9481
2.5x10 BCS
9481
2.5x10 BCS
9483
9483
6783
6783
6783
6783
6783
9482
9482
9481
Sealed Differential Assembly
  • Page 1 1
  • Page 2 2

Traxxas 9495 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI