Cellgate WXL Installation guide

WXL
Brand
Cellgate
Model
WXL
Type
Installation guide

This manual is also suitable for

Cellgate WXL is a secure access control system that allows users to remotely manage and monitor their gates and doors using a mobile app. With its built-in keypad, RFID reader, and Wiegand interface, it supports a variety of access methods, including PIN codes, RFID cards, and keypads. The system also features a built-in camera for added security, allowing users to visually verify visitors before granting access.

Cellgate WXL is a secure access control system that allows users to remotely manage and monitor their gates and doors using a mobile app. With its built-in keypad, RFID reader, and Wiegand interface, it supports a variety of access methods, including PIN codes, RFID cards, and keypads. The system also features a built-in camera for added security, allowing users to visually verify visitors before granting access.

Quick Install Guide
2020
WXL-P Series
INSTALLER TEST CODE:
CODE WILL STOP WORKING AFTER 10 USES.
18 gauge stranded - up to 25 feet.
16 gauge stranded - up to 50 feet.
12 gauge stranded - up to 60 feet.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
CellGate Support: 972-231-1999 option 3
**Recommended wiring: 18/6 shielded for main device, and 18/4 shielded for optional wiegand devices**
Items Included in Kit
❶ Watchman XL Unit
❷ 12 Volt DC Power Supply
❸ Magnetic Read Switch
❹ Keys (Note: Leave one key with the customer)
❺ Nuts X 4
❻ Bolts X 4
❼ Quick Install Guide
❽ Activation & Test Process
❾ Customer Information Packet
Watchman XL Unit Power Supply Wiring
Interface Circuit Board (Oriented the same as the Watchman install)
Important Item
WXL
-
Router
Interface
Circuit
Board
Ethernet
Switch
Interface Wiring Diagram (Oriented the same as the Watchman install)
❶Wire main power from the transformer to the power connector on the
circuit board.
❷Connect gate trigger wires from the Normally Open (NO) and Common (C)
to the free-exit or exit terminals on the gate operator.
❸Connect the gate status wires on the 6-pin connector on the main relay
and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC)
relay on the gate operator.
❹If using an optional 26-bit reader (ex., keypad, card reader, RFID, or
clicker), wire the device to the Wiegand connection on the interface circuit
board.
❺Use Camera Guide if adding optional external camera.
❻Test/activate using the test credentials on the Activation & Test Process
document.
6-Wire Installation Instructions
Important Item
❷
WXL
Installation Testing
Enter the Testing Code, then tap the Enter Button.
The Code will activate Relay 1 (the gate should open).
Enter Button
Locate a Callgroup and tap on it to call it.
An automated message will play confirming the call
was successful.
WXL
Enter a Code
Home
Call List
Callgroup
External Camera Installation.
Customer Information
Installation Complete
• If you’re installing an External Camera, call
CellGate Support for testing.
• CellGate Support: (972) 231-1999 option 3.
Leave the following items with the Customer:
• Customer Information Packet
• WXL - Key
• Customer will setup Account with information in
the Customer Packet.
WXL
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated
with minimum distance 20cm between the radiator& your body.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Cellgate WXL Installation guide

WXL
Brand
Cellgate
Model
WXL
Type
Installation guide
This manual is also suitable for

Cellgate WXL is a secure access control system that allows users to remotely manage and monitor their gates and doors using a mobile app. With its built-in keypad, RFID reader, and Wiegand interface, it supports a variety of access methods, including PIN codes, RFID cards, and keypads. The system also features a built-in camera for added security, allowing users to visually verify visitors before granting access.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents