KUFATEC VW Passat B8 Adaptive Cruise Control Operating instructions

Type
Operating instructions
Installation Instructions
Adaptive Cruise Control (ACC)
VW Passat B8
v1.3 (28.06.2022)
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 1
Contents
1 Liability Exclusion 3
2 Copyright 4
3 General notes 4
4 Safety Instructions 5
5 Requirements for the intended use 5
6 Safety Instructions for working on Airbags 6
7 Assembly Instructions 7
8 Removing front grille / replace radar sensor 8
9 Routing cable set (only for PR-Nr. 6K0) 9
10 Connection CAN High & Low / ignition lead 10
11 Connection ground / cut-off point 11
12 Removing trim panel front camera 12
13 Routing / connection additional wire 13
14 Removing steering wheel airbag 14
15 Exchange pushbutton 15
16 Exchange accelerator (only with built in Cruise Control) 16
17 Cable routing (only with built in Cruise Control) 17
18 Coding with Coding Interface 19
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 2
8 Removing front grille / replace radar sensor
1
2
3
3
Figure 2: Removing front grille / replace radar sensor
Table 1: Removing front grille / replace radar sensor - instructions
Nr. Work step Note
1 Loosen the marked screws of the front grille. 4xT25
2 Remove the front grille by pulling it out forwards.
3 Loosen the screws of the radar sensor and unplug it.
4 Afterwards attach the new sensor including the bracket.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected]e 8
  • Page 1 1
  • Page 2 2
  • Page 3 3

KUFATEC VW Passat B8 Adaptive Cruise Control Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI