©Copyright LOTRONIC 2018 LED UFO-BL / LED UFO-WH 1
‘UFO’ LED Light effect
LED UFO-BL / LED UFO-WH
User Manual
Manuel d’Utilisation
Bedienungsanleitung
Handleiding
Manual de utilizare
Instrukcja obsługi
Manual de Instruções
Navodila za uporabo
Manual de instrucciones
Manuale di Istruzioni
©Copyright LOTRONIC 2018 LED UFO-BL / LED UFO-WH 2
1. Safety Instructions
• Please keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives
this instruction booklet.
• Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
• Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
• The unit is for indoor use only in a dry location.
• Make sure there are no inflammable materials close to the unit during operation.
• In the event of serious operating problem, stop using the unit immediately.
• Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center and always use the same type of spare parts.
• Do not touch any wires during operation as high voltage might be causing electric shock.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
2. Specifications
Supply Voltage: ............................................................................................. AC220～240V 50/60HZ
Power: ........................................................................................................................................ 10W
Light source: ............................................................................... 10mm 48 LEDs, 16R ,16G ,16B
Operating modes： ..................................................................................... Auto-run, Sound Control
Dimensions: ................................................................................................................ 13 x 13 x 4cm
Weight: ......................................................................................................................................150g
3. Installation
The unit should be mounted via its screw holes on the rear side. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating.
4. Operation
The unit can work either automatically or follow the rhythm of the music.
Plug the unit into an appropriate mains outlet that supplies the required voltage for the unit and it will start working.
5. Fixture Cleaning
• Clean with soft cloth using normal glass cleaning fluid.
• Always dry the parts carefully.
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling
centre. Ask your local authorities or your dealer about the way to proceed.
GB
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
