Sytech SYHCT35N Owner's manual

Brand: Sytech

Model: SYHCT35N

Category: Hair trimmers & clippers

Type: Owner's manual

This manual is also suitable for

SYHCT35P

WELCOME

Thank you for purchasing the new hair clipper SY-HCT35. In order to benefit fully from this product please

read the following instructions carefully. Store the instructions manual in a safe place for future reference.

IMPORTANT SAFEGUARDS

• Before the first use of the appliance check that the voltage indicated on the rating label corresponds to

the mains voltage in your home.

• For home use only. Do not use for industrial purposes. Do not use the appliance for any other

purposes than described in this instruction manual.

• Do not use outdoors.

• Always unplug the appliance from the power supply before cleaning and when not in use.

• To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids.

However if this does occur DO NOT TOUCH the appliance, unplug it immediately and contact your

near service center.

• Do not take this product to a bathroom or use near water.

• Do not immerse the recharging stand or adaptor in water.

• Never charge the unit near water.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliances by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not leave the appliance switched on when not in use.

• Do not use other attachments than those supplied.

• Do not operate after any malfunction, cord damage, battery leak, charging stand damage or adaptor

damage.

• Do not attempt to repair, adjust or replace any parts of the appliance. Check and repair any damages

by contacting Sytech Service Center.

• Keep the cord away from sharp edges and hot surfaces.

• Do not place or store the appliance where it can fall or be pulled into a tub or sink.

• Do not pull, twist, or wrap the power cord around the appliance.

• Never insert any objects into the openings of the appliance.

• Before use, make sure that blades are adjusted properly.

• Do not place the appliance while it is operating on any surface, it may cause injury or damage.

• Do not use the appliance with a damaged comb, or with teeth missing from the blades as injury may

occur. NOTE: KEEP THE BLADES OILED

• Do not use the appliance when the skin is infected.

• Do not use the appliance on animals.

• The manufacturer reserves the right to introduce minor changes into the product design without prior

notice, unless such changes influence significantly the product safety, performance, and functions.

When charging:

• Please don’t charge the unit if temperature is lower than 0°C or higher than 40°C.

• Please don’t charge near direct sunlight, or any other heat source

• The standard charging time is 8 hours. In order to avoid damaging the batteries, do not overcharge.

Once the unit is completely charged, remove the adaptor from the base or from the clipper.

Caution:

- Clean the housing using only a cloth slightly dampened with water or a mild soap solution.

- Never use a caustic solution.

- Never submerge the clipper in water.

- Keep away from the children.

- This clipper may become warm during operating and/or charging, this is normal.

- When using, do not pull or hold on the cord, this may cause damage to the user.

- Never touch the moving parts as this may result in severe injuries.

PARTS OF THE SY-HCT35

USE

The SY-HCT35 can be used cordlessly and while it is being charged.

Connect the AC adaptor to one end of the clipper and the other end to the wall outlet to charge the unit

without the base. The unit can also be charged using the charging stand. Connect one end of the adaptor to

the charging base and the other end to the wall outlet. Then place the unit on the charging base and the unit

will charge. For a complete charge it takes about 8 hours. When the unit is fully charged, it can be used

continuously for more than 45 minutes. The clipper has a LED light indicator. During charging, the indicator

light shows red, green when in use, and red and green when using with the cord attached.

BEFORE STARTING THE HAIR CUT

• Select the comb attachment and the level of haircut desired (please see following sections on how to

select haircut level). Place the clipper besides the hair and push the switch button to ON to start using

the hair clipper. Carefully move in the same directions throughout the haircut.

• Check the clipper, making sure that there is no oil between the cutting blade teeth. Turn the unit on to

distribute the oil and to make sure it is running smoothly before using. Wipe off any excess oil. This

should be done before each use.

• In the case of cutting someone else’s hair, seat the person so the head is approximately at the eye level.

This allows ease of visibility while cutting and a better control of the clipper.

• Place a towel around the neck and shoulders of the person getting the haircut.

• Before cutting always comb the hair so it is tangle free.

REMINDERS

• Cut the hair in an even and slow manner. Use short strokes only and work gradually over the entire

head.

• Always take off a little hair at a time; you can always trim off additional hair later.

• As you work, comb the hair frequently back into the style to which you are cutting.

• When cutting with this hair clipper it is better to leave the hair dry, not wet. With dry hair, it is much

easier to control the amount of the hair being cut.

• Cutting hair requires practice so it is always better to leave the hair longer for the first few haircuts until

you become used to the hair clipper levels and how much hair does each level cut.

USING THE COMB ATTACHMENTS

1. Please place the comb (long and sharp ends) into the slots on the sides of the clipper. See picture 1.

2. To remove the comb attachments, gently pull it out as shown below. See picture 2.

Picture 1 Picture 2

USING THE ADJUSTMENT KNOB

1. Press the knob inwards for it to open out. You may now turn the knob clockwise or anticlockwise.

2. Clockwise: increases the cutting length.

3. Anticlockwise: decreases the cutting length.

Picture 1 Picture 2

To close the adjustment knob, simply press it back into the unit as shown below.

MAINTENANCE OF THE BLADES

1. Hold the hair clipper with the backside facing towards you. Then gently push the blade out of the main

body as shown below. Use the cleaning brush to wipe off the hair from the blade and lubricate the

space between the stationary blade and the moving blade with 2 or 3 drops of oil. (See Picture 1)

2. Clean the blade after every few uses. When placing the blades back onto the unit body, make sure it is

well fitted into position before using again. If it is not fixed properly it may result in injuries. (See picture

Picture 1 Picture 2

SPECIFICATIONS

• Professional Electrical Hair Clipper

• Fixed and Moving blade with Titanium coating

• Rechargeable

• Direct Drive function

• Charging time: 8 hours

• Working time: 45 mins

• Level Adjustment for perfect cut

• Powerful and silent motor

• 2 Attachment combs ranging from 3-7.5mm and 13-23mm

• Power source: 100-240V/50Hz, 3V 600mA

• Battery: 2xAA 600. mAh (NI-MH)

• Power: 6W

• Accessories supplied:

o Oil bottle

o Cleaning Brush

o AC Adaptor

DECLARATION OF CONFORMITY

Manufacturer Name: Satyatrade S. L.

Address: Pol.Ind.La Raya. C/ Guadalquivir, 2.

Camarma de Esteruelas, 28816 Madrid

Tel: 902 430 967

Fax: 91 8864285

NIF: B83254763

Manufacturing country: China

Description: Hair Clipper

Sytech® SY-HCT35 complies with the following directives:

CE Standard: Directive 2004/108/CE

LVD Standard: 2006/95/EC

ROHS Standard: 2011/65/EU Restriction of Hazardous Substances

Signed: Ajeet Nebhwani Utamchandani

Sole Administrator

Sytech SYHCT35N Owner's manual

Brand: Sytech

Model: SYHCT35N

Category: Hair trimmers & clippers

Type: Owner's manual

This manual is also suitable for

SYHCT35P

Download PDF

report

Sytech SYHCT35N Owner's manual

This manual is also suitable for

Sytech SYHCT35N Owner's manual

Related papers

Other documents