2. Kmart
  3. 42841142

Kmart 42841142 User manual

  • Hello, I've reviewed the assembly instructions for the Kmart side tables, model 42841142. This document details the steps to assemble the two glass side tables, including attaching mats, frames, tubes, and glass tops using screws. The document also includes care instructions and safety warnings, along with the 5kg maximum safe load. I am ready to answer any questions about the assembly or use of these tables that you may have.
  • What should I use to clean these tables?
    Is it okay to put hot items on the table?
    What is the maximum weight I can put on these tables?
D
Step 1:Paste mat (Part I) on the metal frame (Part A),
as shown in the picture.
Step 2: Put the metal frame (Part A) on the ground,
fasten metal frame (Part A) and each tube ( Part B)
together with screws (Part J).
Step 3: Put the metal frame (Part C) on the top of
tubes (Part B), use screws (Part J) to fasten them
together.
A
B
C
J
J
I
Assembly Instructions 2 GLASS SIDE TABLES 42841142
CARE INSTRUCTIONS: WIPE CLEAN WITH A DAMP OR DRY CLOTH. DO NOT USE ABRASIVE MATERIALS AND SOLVENTS. DO NOT PLACE HOT ITEMS SUCH AS COFFEE
CUPS DIRECTLY ON THE SURFACE OF THIS FURNITURE ITEM. KEEP AWAY FROM WATER AND DIRECT SUNLIGHT. PLACE ON AN EVEN SURFACE. FOR INDOOR AND
DOMESTIC USE ONLY.
WARNING: DO NOT STAND OR SIT ON THIS UNIT. DO NOT USE THIS UNIT UNLESS ALL BOLTS AND SCREWS ARE FIRMLY SECURED. USE ONLY ON AN EVEN
SURFACE. THIS PACKAGE CONTAINS SMALL PARTS AND SHARP POINTS. KEEP AWAY FROM CHILDREN AND BABIES. ADULT ASSEMBLY REQUIRED. A MILD ODOUR
MAY BE PRESENT WHEN FIRST OPENING THIS CARTON. SIMPLY ALLOW TO AIR OUTSIDE AND THIS WILL FADE. MAXIMUM SAFE LOAD: 5KG.
A1PCS
B3PCS
C1PCS
D1PCS
E1PCS
F3PCS
G1PCS
H1PCS
I
J24PCS
K1PCS
8PCS
Metal Frame
Tube
Metal Frame
Glass
Metal Frame
Tube
Metal Frame
Glass
Mat
M5x10mm
Screw
Hex key
Hardw
are list
ATTENTION:
DO NOT TIGHTEN THE SCREWS
FULLY DURING ASSEMBLY.
Step 4: Place glass (Part D) on the top of metal frame
(Part C), one is assembled.
Step 8: Place glass (Part H) on the top of metal frame (Part G),
another one is assembled.
E
F
G
H
JJ
I
Step 5: Paste mat (Part I) on the metal frame
(Part E),as shown in the picture.
Step 6: Put the metal frame (Part E) on the
ground, fasten metal frame (Part F) and each
tube ( Part B) together with screws (Part J).
Step 7: Put the metal frame (Part G) on the top
of tubes (Part F), use screws (Part J) to fasten
them together.
Step 9: Assembly is now complete.
/