& SAFETY INFORMATION
CAUTION:
CAUTION: Risk of fire. Min. 90°C supply conductors. Consult a qualified electrician to ensure correct branch circuit
conductor
WARNING:
CAUTION:
PREPARATION
CARE AND MAINTENANCE
ASSEMBLY INSTRUCTIONS
1 1. Loosely thread the hex nut (AA) onto the nipple
(FF) and then install this assembly onto the
mounting strap (CC). Next, install this assembly to
the outlet box using the mounting screws supplied
with the outlet box (not included).
2. In this step, you will adjust the depth of the
nipple in relation to the canopy depth.
Take the canopy (HH) and slip it over the nipple
(EE). You will need to adjust the nipple so at least
1/4" of the threaded portion is exposed through
the canopy hole. This is done by adjusting the
depth of the nipple (FF) on the mounting strap
(CC). When the nipple depth is correctly adjusted,
remove the canopy (HH) and tighten the hex nut
(AA) against the mounting strap (CC).
Thread nipple up
& down r adjustment