2. C.E. Niehoff
  3. A10-135 Pulley Tool

C.E. Niehoff A10-135 Pulley Tool Operating instructions

  • I've reviewed the instructions for using the Pulley Tool for CEN Alternators. The document outlines the steps for installing the pulley, using a torque tool, and securing the pulley nut with the correct torque settings. I'm here to help you with any questions you have regarding this process.
  • How to install the pulley?
    What tool is used to hold the pulley in position?
    What to do after tightening the pulley nut?
II0077B
Page 1 of 1
Pulley Tool for
CEN Alternators
Instructions
C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633
Breaker Bar
Torque wrench
T
T
Hardware
T
Figure 1 — Pulley Tool
Pulley Tool
T
Pulley
T
Alternator
T
How to Use Pulley Tool
1. Install pulley on alternator shaft. Fasten with hardened washer and pulley nut.
2. Place pulley nut torque tool on top of pulley and snugly fasten hardware sized specifically for the holes in the
pulley.
3. Hold pulley tool in position with breaker bar.
4. Tighten pulley nut to torque specified by alternator model number.
5. Remove hardware and pulley tool after pulley nut is tightened.
/