YITAHOME SHMYD-V1 User manual

Type
User manual
ASSEMBLY INSTRUCTIONS
SHMYD-V1
PORTABLE EV CHARGER
ASSEMBLY INSTRUCTIONS
11
Item Level 2 Portable EV Charger
Rate Current
Input Voltage AC
Rate Frequency
Waterproof Degree
Working Temperature
Withstand Voltage
Shell Material
Terminal Material
Flame Retardant Grade
Operating Humidity
Mechanical Life
Pressure Impact Force
Cable Length
Standard
Step 1. Take out the charger and firmly insert the power plug into the wallend outlet socket.
Step 2. Please press the button of "CURRENT " to adjust your required current. Or please press
the button of " DELAY " to adjust your charging time. The device will default to the last
current setting when we charge next time.
Step 3. Insert the charging plug (Car End) into the car side charging inlet, the device start
charging automatically while the READY/CHARGEPOWER indicators are all green.
Certificatevv
A.6A/8A/10A/13A/16A
B.10A/16A/20A/24A/32A
C.16A/20A/24A/32A/40A
110V~240V
50Hz/60Hz
IP67
-25℃~+55℃
2000V
PC
Copper Alloy Silver Plating
UL94 V-0
20%-85%
No-Load Plug In / Pull Out >10000 Times
Can afford 1m drop and 2t vehicle run over
pressure Impact Force
25FT
IEC 62752 , IEC 61851
TUV,CE,UKCA,FCC
ASSEMBLY INSTRUCTIONS
2
Step 1. Please take out the EV charging gun from car side after the car charging is complete.
Step 2. Disconnect the power plug from the wall socket-outlet.
Step 3. Pack up the EV charger cable and put into the bag.
1.Short Circuit Protection
2.Over and Under Frequency Protection
3.Over Current Protection
4.Leakage Current Protection (restart recover
5.Over Temperature Protection
6.Overload Protection (self-checking recover)
7.Ground Protection
8.Surge Protection
9.Over Voltage and Under-voltage Protection
1.This is a Level 2 EV charging cable don't use it for EV's other different inle types.
2.Please check if the device is intact and items are accordance with the packing list when
you receive the package.
3.Do not submerge the EV control box or EV charging connector in water.
4.Do not use the charger if the EV controller box is damaged.
5.Don't charge if the wall socket is damaged, rusted, cracked or loosely connected.
6.Wipe with a clean and dry cloth if the plug gets dirty or wet.
8.Do not use this device with an extension cord or an adapter.
9.Do not place the charging cable near high temperature object when it is working.
10.Do not use this device with an extension cord or an adapter, Please do not disconnect
the plugs while the EV charger is charging the vehicle.
7.The device must be grounded.
CONTACT US:
,
󽩘󽩟󽩟󽩟󽩞󽩘󽩞󽩟󽩗󽩟󽩛󽩟󽩗󽩗󽩛󽩚󽩗󽩟󽩗󽩗󽩘󽩙󽩗󽩗


󽩘
󽩙󽃡
󽩚
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

YITAHOME SHMYD-V1 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI