Midland Radio MXAT01VP Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Midland Radio MXAT01VP Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
5900 Parretta Drive KANSAS CITY, MO 64120
PHONE: (816) 241-8500 FAX: (816) 241-5713
EMAIL: mail@midlandradio.com
WEBSITE: midlandusa.com
Midland Radio Corporation
midlandusa.com
10/16/2022
MXAT01 NMO Mount Assembly Diagram
1. The MXAT01 NMO mount is designed for mounting brackets or surfaces up to 1/2" thick.
2. The MXAT01 NMO mount is designed to be installed in a 1/2" hole, commonly used for 3/8” stud mount
CB antennas.
3. Part C should be adjusted so the center conductor on the Part D NMO interface extends 9/32” to 5/16”
beyond the mounting surface, or just above the top surface of Part A when installed.
4. Use the hex head on the Part D NMO interface to hold it in position while Part A is installed and tightened.
5. Part A is installed on top of the bracket or mounting surface with the wrench flats up and the O-ring
down. The rubber O-ring on the bottom of part A acts as a seal to prevent water entering the mounting
surface hole. Maximum torque: 32 lb-ft.
6. The hex head can also be used to hold the NMO interface in position while tightening the PL259
connector, Part F, by hand.
7. The center conductor of Part D should end up 1/32” to 1/16” proud of Part A to properly interface with
the MXAT01 antenna. Tighten the antenna by hand, to just snug.
/