2. BLOTZ
  3. B20-ME-108

BLOTZ B20-ME-108, B20_ME_108, BH0-ME-108 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the Desert Fort Short Wall - Door model (B20-ME-108). This document provides steps for the model's construction, including how to attach the walls, roof, and door using glue, as well as the necessary tools. I'm ready to answer any questions you have about this assembly guide.
  • What kind of glue is required?
    What tools are needed?
    Are there any recommended techniques?
20mm Desert Fort – Short Wall - Door
B20-ME-108
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
[Optional] Glue the door behind the doorway.
Add the front wall.
Attach the base, slotting each lug into the
associated hole.
The finished model.
/