2. AUMA
  3. Retrofit Kit

AUMA Retrofit Kit Operating instructions

  • Hello! I've analyzed the provided document, which details the installation process for the PROFOX Z137.637 retrofit kit. This kit is designed to add a 24 V DC auxiliary voltage output to your PROFOX actuator. The instructions cover steps like connecting the cable harness and inserting the spring clamp terminal. I'm ready to answer your questions about this device and its installation.
  • What is the purpose of this retrofit kit?
    What components are included in the delivery?
    What is the first step in the installation procedure?
Z137.637
Retrofit kit for PROFOX auxiliary voltage output 24VDC
References for assembly
Y009.381/003/en Issue 1.23 Page 1/1
Scope of delivery
Units Article no. Description
4K011.625 Spring clamp terminal
1Z133.346 Cable harness
References for assembly
Please always heed safety and warning instructions of operation instructions throughout all steps.
Kit Article no. Description
1Z137.637 Retrofit kit for PROFOX auxiliary voltage output 24VDC
Fig. 1
Reference documents
• Operation instructions pertaining to actuator
Reference documents are available on our website: www.auma.com
This description applies to the following retrofit kit:
Fig. 2
Fig. 3
Fig. 4
Procedure:
1. De-energise PROFOX actuator and protect against reconnection.
2. Remove the screws from the actuator housing cover and take off housing
cover (fig.1).
3. Insert the red [1] and the black cable [2] of the cable harness into one
spring clamp terminal each as shown in fig.2.
4. Insert the “spring clamp terminal” module into the electronic carrier
(fig.3).
5. Laterally wind the cable harness around the electronic carrier (fig.4) and
insert the plug/socket connection of the cable harness into the power
supply unit (fig.5).
6. Close the housing cover of the actuator and fasten the screws.
[2]
[1]
Fig. 5
/